6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
6 <strong>Configuration</strong> <strong>commands</strong> - <strong>for</strong> <strong>Falcom</strong> <strong>STEPP</strong><br />
This chapter explains the configuration <strong>commands</strong> <strong>for</strong> <strong>Falcom</strong> <strong>STEPP</strong>.<br />
There are two categories of configuration <strong>commands</strong>:<br />
• Commands <strong>for</strong> SMS remote configuration<br />
• Commands <strong>for</strong> direct configuration of a <strong>Falcom</strong> <strong>STEPP</strong> connected to<br />
<strong>STEPP</strong>config<br />
In Table 22 you will find an overview of the <strong>commands</strong> <strong>for</strong> SMS remote<br />
configuration of a <strong>Falcom</strong> <strong>STEPP</strong>.<br />
Please note<br />
If a password has been defined <strong>for</strong> the device, then the user should send<br />
this password each time in the configuration SMS message, otherwise,<br />
the <strong>STEPP</strong> could not be configured remotely via SMS.<br />
The entered password which will be displayed in the corresponding input<br />
field (see “general parameters” image 9) is encrypted, applying a 160-bit<br />
key function.<br />
For example the user of <strong>Falcom</strong> <strong>STEPP</strong> has entered the password<br />
, the encrypted one, which will be displayed in its input field<br />
after the user has sent it to the <strong>Falcom</strong> <strong>STEPP</strong>, is . In order<br />
to configure the <strong>Falcom</strong> <strong>STEPP</strong>, please use the password. The<br />
encrypted one is unacceptable.<br />
Important:<br />
Important 1:<br />
Take into account, that all configuration <strong>commands</strong> sent to the<br />
<strong>STEPP</strong> (via SMS, data connection or locally) should be match<br />
exactly the parameter <strong>for</strong>mat (Sysntax) described in this manual.<br />
!!! Note that incorrect assigned parameter into a configuration<br />
command may carry the <strong>STEPP</strong> device into the instability<br />
conditions (such as the <strong>STEPP</strong> could not be available, could not<br />
pick up a voice call etc.) and its configuration can only locally be<br />
improved (via a direct connected <strong>STEPP</strong> device).<br />
To get a GPS fix, the vehicle should be in stationary state <strong>for</strong> about<br />
1 minute. By moving, while <strong>STEPP</strong> does not have a GPS fix, the<br />
TTFF (Time-To-Fist-Fix) could be delayed <strong>for</strong> several minutes.<br />
If the History function of the <strong>STEPP</strong> is enabled, the events of<br />
$GPIOP protocol will be automatically stored into the History after<br />
each Reset procedure occurred by the <strong>STEPP</strong> device.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 72