6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
Entry Description<br />
Alarm phone no. (a) Enter the target number where an alarm SMS is to be sent to<br />
Alarm text (b) Enter the text of the alarm SMS<br />
Select alarm type (c) Enter the alarm type of the alarm message to be sent<br />
Cancel (d) Cancel the configuration<br />
Table 13: Configure the alarm<br />
The SMS window allows you to:<br />
• initiate a once-off or a recurring SMS position transmission through a<br />
<strong>Falcom</strong> <strong>STEPP</strong> to the connected <strong>Falcom</strong> SWING<br />
• send a SMS configuration command to a <strong>Falcom</strong> <strong>STEPP</strong><br />
• send a SMS configuration command from a list of predefined <strong>commands</strong><br />
4.3.2.2 SMS Position request<br />
4.3.2.2.1 To start a position request via SMS, please follow the steps below:<br />
1. By clicking the +/- buttons in field 4, select the desired time interval at<br />
which SMS’s are to be transmitted to you. The interval initiates a<br />
once-off position transmission. Every other value causes the <strong>Falcom</strong><br />
<strong>STEPP</strong> to transmit SMS position messages at the set interval (in<br />
minutes).<br />
2. Click on the “read car position” button (3) to activate the position<br />
transmission in <strong>Falcom</strong> <strong>STEPP</strong>.<br />
W a r n i n g<br />
Please don’t <strong>for</strong>get that a running automatic position transmission must<br />
be finalised with a once-off position request with the parameter .<br />
Otherwise you could incur considerable costs.<br />
4.3.2.2.2 SMS Remote configuration with predefined <strong>commands</strong><br />
For SMS remote configuration of a <strong>Falcom</strong> <strong>STEPP</strong>, a list of predefined<br />
<strong>commands</strong> is available in the list 7 “select command”.<br />
With the help of these <strong>commands</strong> it is possible to:<br />
• Change the status of the outputs of a <strong>Falcom</strong> <strong>STEPP</strong><br />
• Configure the alarm inputs<br />
• Change the device name or the device password of a <strong>Falcom</strong> <strong>STEPP</strong><br />
• Prompt the <strong>Falcom</strong> <strong>STEPP</strong> to establish a voice, data or alarm call to its<br />
GSM modem (<strong>Falcom</strong> SWING)<br />
For remote configuration, choose one of the predefined <strong>commands</strong> in the list<br />
and send it by clicking on the “send command” button (8).<br />
To configure the alarm input, additional in<strong>for</strong>mation is required (see image 10).<br />
Complete the fields “Alarm phone number”, “Alarm text” and “Alarm type”,<br />
and send the command by clicking on the “send command” button (8).<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 53