6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
Parameter Description<br />
<br />
Request device (vehicle) position every minute(s).<br />
Notes<br />
• If no period is given (it is omitted), the position (GPGGA and<br />
GPRMC) is sent once and the MSG parameter remains unmodified (h) .<br />
• If a period is specified (in seconds), the on the MSG<br />
parameter is also modified so that the position is sent periodically.<br />
• If the period is set to 0, the system responds OK and it stops<br />
sending of periodic messages. The MSG parameter gets modified (h) .<br />
6.4.4 &REQ [PWD] POS (c) Configure and request vehicle position with<br />
defined period<br />
&REQ [PWD] POS<br />
Command<br />
,,,,,,,<br />
Examples &REQ PWD POS 4,0,0,0,0,0,0,RMCIOP<br />
&REQ PWD POS 4,0,0,0,50,25,50,RMC<br />
&REQ PWD POS 4,30,0,0,50,25,50,RMC<br />
&REQ PWD POS 4,60,0,0,50,25,50,GGAIOP<br />
&REQ POS 4,60,0,0,50,25,50,GGAIOP<br />
Command Description<br />
Using this command the <strong>STEPP</strong> device can be configured and based on the<br />
user limited configuration. It is able to implement it and in case of limited<br />
configuration is exceeded, the <strong>STEPP</strong> sent the position requested by the user;<br />
either <strong>for</strong> just one time or periodically (depends on the user set value).<br />
The position (a SMS message containing one of possible combination of<br />
NMEA sentences, e.g. $GPRMC and $GPIOP) is returned to the message<br />
sender every second(s).<br />
To understand and properly set the following parameters, please, refer to the<br />
chapter 6.3. In that chapter you will find detailed in<strong>for</strong>mation about the set<br />
parameters.<br />
Parameter Description<br />
<br />
It specifies the minimum number of satellites in view (recommended > 3)<br />
<br />
It specifies the minimum time. The unit is second [s]<br />
<br />
It specifies the maximum time. The unit is second [s]<br />
<br />
It specifies the minimum distance. The unit is meter [m]<br />
<br />
It specifies the maximum distance. The unit is meter [m]<br />
<br />
h<br />
The Firmware 1.6.10 and greater versions support this parameter.<br />
h<br />
The Firmware 1.6.10 and greater versions support this parameter.<br />
c<br />
The Firmware 1.4 and greater versions support this SMS command.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 104