6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
6.3.17 GEOMSG<br />
• If the object (vehicle fitted with the FALCOM <strong>STEPP</strong>) leaves (i) the<br />
predefined master region, the SMS message delivered from the <strong>STEPP</strong><br />
device to the target phone number specified by the<br />
GEOMSG parameter includes:<br />
- the device name (if predefined),<br />
- the predefined text “GEO-ALARM 0”<br />
- closed by the user selected protocols either by the WATCH or<br />
GEOMSG parameter.<br />
e.g.<br />
+CMT: "+4917610022382",,"05/06/27,10:44:20+08"<br />
<strong>STEPP</strong> GEO-ALARM 0<br />
$GPRMC,084509.984,A,5040.3998,N,01058.8412,E,0.06,350.84,27<br />
0605,,*05<br />
$GPIOP,11000000,00000000,0.71,5.25,4.11*73<br />
Syntax GEOMSG=,,,,,,<br />
,,<br />
This parameter is the same one as the MSG parameter, however it must be used<br />
<strong>for</strong> geo-fencing configuration, only. That means a SMS message is sent to the<br />
specified phone number , and not to the phone number m_phone<br />
specified by the MSG parameter. Additionally, the parameter GEOMSG is<br />
independent of the MSG parameter configuration.<br />
A SMS message is sent to the specified phone number when the<br />
minimum number of satellites is available and the condition specified in<br />
all , and values or just one of , and<br />
values are satisfied. The SMS message may contain up to two GPS<br />
protocols specified in parameter. Messages are not sent more<br />
frequently than one message every 30 seconds.<br />
:<br />
It specifies the type of alarm. It can be set to S, D, V or A corresponding<br />
to a SMS alarm, Data call, Voice call or Alarm (listen-in mode) call<br />
respectively, see also sections 4.3.9.1 and 4.3.9.2.<br />
:<br />
It specifies the phone number where the alarm has to be sent.<br />
<br />
It specifies the minimum number of satellites in view (recommended > 3)<br />
<br />
It specifies the minimum time. The unit is second [s]<br />
<br />
It specifies the maximum time. The unit is second [s]<br />
<br />
It specifies the minimum distance. The unit is meter [m]<br />
<br />
It specifies the maximum distance. The unit is meter [m]<br />
<br />
i<br />
Feature of the Firmware 1.8.14 and greater versions<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 97