6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
Image 16: Main window<br />
Entry Description<br />
Status In<strong>for</strong>mation (1, 2) This field gives in<strong>for</strong>mation to the current connectivity<br />
Car & Phone (3, 4)<br />
GSM event protocol<br />
ON/OFF ($GPGSM) (11)<br />
device event protocol<br />
ON/OFF ($GPIOP)(11)<br />
Voice call (5)<br />
Hangup (6)<br />
Configure and filter GPS<br />
protocols (9)<br />
(Online, Offline, Dialling)<br />
This field gives you a choice of all the vehicles registered<br />
under “Settings-Cars”. The telephone number of the chosen<br />
vehicle will display in the Phone field (4). The selection of<br />
a vehicle is the basis <strong>for</strong> all Voice, Data and SMS<br />
interactions.<br />
Clicking the checkbox to switch on the continuous GSMstatus<br />
transfer within the data line to a <strong>Falcom</strong> <strong>STEPP</strong>, or<br />
uncheck it to switch this option off.<br />
Clicking the checkbox to switch on the continuous status<br />
transfer within the data line to a <strong>Falcom</strong> <strong>STEPP</strong>, or<br />
uncheck it to switch this option off.<br />
By clicking on this button you can activate the<br />
establishment of a voice or alarm call (depending on the<br />
configuration of the modem – <strong>Falcom</strong> <strong>STEPP</strong>).<br />
By clicking on this button you will terminate an active<br />
voice or alarm call.<br />
Switches the GPS protocols on and off<br />
(GPGGA, GPRMC, GPGSV, GPGSA, GPGLL).<br />
It displays the filter of protocols from the data stream of<br />
received NMEA protocols, too.<br />
Terminal (10) During communication, the terminal window will display<br />
the sent and received <strong>commands</strong> and data.<br />
Remote access start (7) Starts a data line to the vehicle as chosen in field 3<br />
Remote access stop (8) Ends the data line to the vehicle as chosen in field 3<br />
Status in<strong>for</strong>mation<br />
COM Port (12)<br />
Status in<strong>for</strong>mation<br />
general (13)<br />
Table 11: Remote Window<br />
In<strong>for</strong>mation on the defined COM Port<br />
Displays general in<strong>for</strong>mation during the program run, such<br />
as GSM Provider, Service mode, etc.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 48