6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
message index starting from 00. In the last message, CNF is replaced by<br />
ENDxx. See respond messages in table above.<br />
6.4.6 &REQ [PWD] CONNECT Initiate a return call as a data call<br />
Command &REQ [PWD] CONNECT <br />
Examples &REQ PWD CONNECT 1234567<br />
&REQ CONNECT +491234567<br />
&REQ PWD CONNECT 0221345789<br />
&REQ PWD CONNECT<br />
Command Description<br />
Using this command the <strong>STEPP</strong> device can be instructed to start a GSM<br />
connection. It initiates a return call from the device as a data call and<br />
transfers the set GPS protocols.<br />
The target phone number can also be other receiver (not the message<br />
sender). The <strong>STEPP</strong> device will transfer its GPS positions to the target userspecified<br />
phone number.<br />
Parameter Description<br />
<br />
It specifies the target phone number where the GSM data connection has to<br />
be established. The specified call number should to be <strong>for</strong> data call.<br />
Notes<br />
• If no number is given, the device will start a data connection to the<br />
message sender.<br />
6.4.7 &REQ [PWD] PHONE [phone] Initiate a listen or voice call<br />
Command &REQ [PWD] PHONE <br />
Examples &REQ PHONE1 0123405<br />
&REQ PHONE2 0123045<br />
Command Description<br />
Using this command the <strong>STEPP</strong> device can be instructed to start a GSM<br />
connection. It initiates a return call from the device as an alarm or voice call.<br />
The target phone number can also be other receiver (not the message<br />
sender). The <strong>STEPP</strong> device will establish an alarm or voice call to the target<br />
specified phone number. Please, refer to the chapter 4.3.1.2.1 and 4.3.1.2.2<br />
<strong>for</strong> more in<strong>for</strong>mation about the voice and alarm calls.<br />
Parameter Description<br />
<br />
It specifies the entry index of call connection type. The following values are<br />
supported:<br />
1 initiates a return call from the device as an alarm (listen-in mode)<br />
call<br />
2 initiates a return call from the device as a voice call<br />
<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 106