6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
The command to select history data could be:<br />
$PSRF109,0,031103,162849*33<br />
• to select history data from 03.11.2003<br />
• from the time 16:28:49<br />
• in NMEA <strong>for</strong>mat (0)<br />
A Checksum calculator is integrated into the <strong>STEPP</strong>config in order to support<br />
your progress in the practical application. This will aid you in calculating the<br />
checksum (in example *33), which is required <strong>for</strong> all extended NMEA<br />
<strong>commands</strong> (see chapter 4.2.2).<br />
The Checksum calculator is started via the menu option “Service mode –<br />
CheckSum - Calculator”.<br />
It is possible to transfer the stored data to the GPS port of a suitable map<br />
software program (Map&Guide®, Infomap®, Microsoft®-MapPoint® or<br />
another). This can be done with the included “send history” tool, which is<br />
started by clicking on the “send history to COMxx” button (3).<br />
4.3.5 Send History Tool<br />
The “history tool” will open when clicking on the “send history to COMxx”<br />
button (3) in the history window.<br />
This tool allows you to send saved history log files, such as “history.log” or<br />
“alarm.log” (see below), to the configured serial port, as described in chapter<br />
3.2.1.2.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 58