6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
in view (3) Number of visible satellites<br />
Time (4) Displays GPS time<br />
Date (5) Displays GPS date<br />
Latitude (6) Co-ordinates - Latitude<br />
Longitude (7) Co-ordinates - Longitude<br />
display (8) Displays protocols valid / invalid<br />
Satellite Level (8)<br />
Table 18: Satellite status<br />
Displays the quality of reception of all visible<br />
satellites<br />
When activating the field “SatPos” (2), the window “Satellites in view” (Image<br />
24) will open.<br />
This window shows the positions obtained from the $GPGSV protocol from<br />
the current visible satellites in orbit.<br />
Please note<br />
4.3.8 Info window<br />
The accuracy of the GPS data depends on the number of satellites and<br />
their positions in orbit. The greater the number of visible satellites, and<br />
the higher they are above the horizon, the more accurate the GPS data<br />
becomes.<br />
Image 24: Satellite positions (example)<br />
By clicking on the “Info…” tab, a window will open which gives you general<br />
guidelines <strong>for</strong> installing a <strong>Falcom</strong> <strong>STEPP</strong>.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 62