6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
SMS &CNF PWD UNIT GSMRESET=3<br />
command &CNF PWD UNIT GSMRESET<br />
NMEA $PSRF108,GSMRESET=3*00<br />
message $PSRF108,GSMRESET*0E<br />
Notes<br />
• If a <strong>STEPP</strong> originated data call is set up (indicated by the result code<br />
“CONNECT 9600”) and no GPS protocols or data are being transmitted<br />
to the other call party, the <strong>STEPP</strong> device resets the GSM engine after<br />
user-defined timeout is exceeded. The countdown starts when the result<br />
code “CONNECT 9600” appears to the called party.<br />
• To stop the GSM reset, a SMS message without value has to be sent to<br />
the device.<br />
6.3.14 GSMWRST (h)<br />
Syntax GSMWRST=<br />
This parameter has the ability to reset the GSM engine (WAVECOM module)<br />
of <strong>STEPP</strong> device in interval of times. The reset occurs when the specified<br />
amount of time, determined by the property, has passed and no GSM<br />
activities are available at this time.<br />
<br />
It determines the amount of time, in minutes, that passes be<strong>for</strong>e the GSM<br />
engine initiates another reset. The is an integer value. The default<br />
value is 1440 (24 hour).<br />
How the parameter could be sent:<br />
SMS &CNF PWD UNIT GSMWRST=720<br />
command &CNF PWD UNIT GSMWRST<br />
NMEA $PSRF108,GSMWRST=720*00<br />
message $PSRF108,GSMWRST*0E<br />
Notes<br />
6.3.15 MSG<br />
• If the value is set to 0, the system deactivates the reset procedure.<br />
• If the parameter value is omitted, the <strong>STEPP</strong> resets this parameter to<br />
default value of 1440 min (=24 hour).<br />
Syntax MSG=,,,,,,,<br />
,<br />
This parameter can be used to configure the <strong>STEPP</strong> device <strong>for</strong> periodically<br />
delivering the GPS protocols. The configuration depends on the on view<br />
satellites and the minimum or maximum time, distance and speed. If all<br />
minimum values or just one maximum value is exceeded, then the <strong>STEPP</strong><br />
triggers an alarm SMS to the specified phone number.<br />
h<br />
The Firmware 1.6.10 and greater versions support this parameter.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 93