6 Configuration commands - for Falcom STEPP

STEPPCONFIG VERSION 1.8.14
[FalcomSTEPP-History-File generated: 1/28/2003]
Position1=$GPGGA,095150.000,5040.4014,N,01058.8657,E,1,04,1.0,494.6,M,,,,0000*0D
Position2=$GPRMC,095150.000,A,5040.4014,N,01058.8657,E,,,280103,,*03
Position3=$GPGGA,095200.000,5040.4014,N,01058.8657,E,1,04,1.0,494.6,M,,,,0000*0B
Position4=$GPRMC,095200.000,A,5040.4014,N,01058.8657,E,,,280103,,*05
Position5=$GPGGA,095210.000,5040.4014,N,01058.8657,E,1,04,1.0,494.6,M,,,,0000*0A
“Alarm.log”-File
When an alarm SMS is received, STEPPconfig will create this file with an
attached GPS position.
The file has the following format:
[SMSalarms]
1/9/2003 10:27:36
AM=$GPGGA,092648.343,5040.3946,N,01058.8645,E,1,06,1.5,487.4,M,,,,0000
1/9/2003 10:40:18
AM=$GPGGA,093930.058,5040.3968,N,01058.8613,E,1,07,1.3,488.0,M,,,,0000
1/9/2003 1:28:07
PM=$GPGGA,122718.903,5040.3980,N,01058.8646,E,1,06,1.3,494.3,M,,,,0000
To send a saved log file via the serial port to a map software, please
proceed as follows:
1. Click on the “read logfile” button (7), and from the subsequent
dialogue box, choose the log file to be sent.
The data sets contained in the file will display in the terminal
window (1), and the number of data sets in the file will display in the
field “records” (4).
2. Click on the “send logfile” button (8) to send the log file to the COM
port as defined under “Settings” (see chapter 3.2.1.2).
You can cancel the task any time by clicking on “cancel” (9).
If you double-click on one of the data sets shown in the terminal
window (1), any previously started transfer will be terminated and
the chosen data set sent to the serial port.
3. Exit closes the “History Tool” window
4.3.6 Alarms window
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 60