6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
An SMS message is sent to the specified phone number when the<br />
minimum number of satellites is available and the condition specified in<br />
all , and values or just one of , and<br />
values are satisfied. The SMS message may contain up to two GPS<br />
protocols specified in the field. Messages are not sent more<br />
frequently than one message every 30 seconds (default setting).<br />
:<br />
It specifies the alarm type. It can be set to S, D, V or A corresponding to<br />
a SMS alarm, Data call, Voice call or Alarm (listen-in mode) call<br />
respectively, see also sections 4.3.9.1 and 4.3.9.2.<br />
:<br />
It specifies the phone number where the alarm has to be sent.<br />
<br />
It specifies the minimum number of satellites in view (recommended > 3)<br />
<br />
It specifies the minimum time. The unit is second [s]<br />
<br />
It specifies the maximum time. The unit is second [s]<br />
<br />
It specifies the minimum distance. The unit is meter [m]<br />
<br />
It specifies the maximum distance. The unit is meter [m]<br />
<br />
It specifies the minimum speed. The unit is kilometers per hour [km/h]<br />
<br />
It specifies the maximum speed. The unit is kilometers per hour [km/h]<br />
:<br />
It defines the input GPS protocols, which will be sent to the message<br />
sender, only if the alarm type is set to S (<strong>for</strong> SMS).<br />
How the parameter could be sent:<br />
SMS &CNF [PWD] UNIT MSG=S132345678,4,60,0,0,0,0,0,RMCIOP<br />
command &CNF [PWD] UNIT MSG=S0125156105,4,60,0,0,0,0,0,RMCIOP<br />
NMEA $PSRF108,MSG=S132345678,4,60,0,0,0,0,0,RMCIOP*06<br />
message $PSRF108,MSG=S0125156105,4,60,0,0,0,0,0,RMCIOP*62<br />
Notes<br />
• If all , and limits are exceeded and minimum<br />
number of satellites is available, SMS messages will periodically<br />
be sent to the specified phone number. Any null value is ignored.<br />
• If any of , and limits is exceeded and minimum<br />
number of satellites is available, SMS messages will periodically<br />
be sent to the specified phone number. Any null value is ignored.<br />
• To stop transferring of such protocols the command &REQ POS 0 or<br />
&CNF UNIT MSG (without parameters) has to be sent to the device.<br />
• The phone number can also be another participant<br />
(message receiver), different one from the message sender. The <strong>STEPP</strong><br />
device transfers the GPS protocols to the assigned participant. This<br />
feature allows the specified participants to have knowledge of the<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 94