6 Configuration commands - for Falcom STEPP

STEPPCONFIG VERSION 1.8.14
• If the field is specified to 0, the selected message will
be disabled (switched OFF).
6.5.3 $PSRF109,[data][*ChSum] Download the history data
Command $PSRF109,,,,,
Examples $PSRF109,1,280104,155811,300104,150000*36
Command Description
Download history from STEPP using specified parameters. This
command enables you to retrieve stored GPS history data either from a
directly connected STEPP or from communicating one via a data line.
The data into the on-board memory are stored according to UTC Time
(Universal Time Coordinated). Therefore, the parameters of this
command are also based on the UTC time.
Command Description
It specifies the download history format. The GPS data can be
configured in the following data formats:
0 corresponds to the request history in the NMEA format
1 corresponds to the request history in the binary format
Specifies the start date. Its format is DDMMYY
Specifies the start time. Its format is HHMMSS
Specifies the end date. Its format is DDMMYY
Specifies the end time. Its format is HHMMSS
CheckSum has to be calculated.
Notes
• To download the history data, please consider the UTC Time, otherwise
you will download the stored data in the incorrect time.
6.6 GPIOP format protocol
The $GPIOP status protocol appears in the following format:
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 113