6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
The Yellow LED<br />
(GPS) flashes (4sec.<br />
interval)<br />
• SIM card has not been<br />
inserted<br />
• PIN number is incorrect<br />
configured<br />
• The start-up of GSM engine<br />
has detected an error.<br />
• SIM card has been changed<br />
which has another PIN code<br />
of the first one<br />
(without the SIM), then start<br />
up the <strong>STEPP</strong>config software.<br />
Go to “Service Mode” ><br />
“Device basis configurations”.<br />
Delete the PIN in the<br />
corresponding field and press<br />
the button “Send”.<br />
- Close the Config<strong>STEPP</strong><br />
software and switch off the<br />
<strong>STEPP</strong> device.<br />
- Remove the SIM card from<br />
your mobile or GSM modem<br />
and insert it into the <strong>STEPP</strong>.<br />
- Switch on the <strong>STEPP</strong> device<br />
and start again the<br />
Config<strong>STEPP</strong> software<br />
- Go to “Service Mode” ><br />
“Device basis configurations”.<br />
Enter the new PIN code in the<br />
corresponding field, then press<br />
the button“Send”.<br />
• Please insert the SIM card<br />
correctly<br />
• Configure the correct PIN<br />
number within the Service-<br />
Mode-Configure device<br />
parameters<br />
• Power down the <strong>Falcom</strong> <strong>STEPP</strong><br />
and power it up again.<br />
• Please try to do the same steps<br />
described in the previev row on<br />
the same column.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 119