6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
6.1 SMS and PSRF Command syntax<br />
6.1.1 SMS Command syntax<br />
The SMS <strong>commands</strong> can be sent to the device same as a SMS text, but their<br />
<strong>for</strong>mat have to be considered. The "&CNF" or "&REQ" command header must<br />
be set at the beginning of each command line. In <strong>commands</strong> described below,<br />
the SMS password is indicated as [PWD] enclosed in square brackets or PWD,<br />
indicating that it is an optional field.<br />
Types of SMS <strong>commands</strong>:<br />
Command type Syntax Function<br />
Readable<br />
command<br />
Writable<br />
command<br />
Executable<br />
command<br />
Clear Command<br />
&REQ [PWD] CNF<br />
&CNF [PWD] UNIT<br />
=<br />
&CNF [PWD]<br />
<br />
&CNF [PWD]<br />
<br />
6.1.1.1 SMS Command structure<br />
This command returns the currently<br />
set value of the parameter or<br />
parameters.<br />
This command sets user-definable<br />
parameter values.<br />
This command per<strong>for</strong>ms an event<br />
to the device.<br />
This command deactivates that<br />
parameter name (deletes the<br />
value(s)) which previously have<br />
(has) been specified.<br />
In table below you will find two types of the SMS <strong>commands</strong>, which can be<br />
sent to the <strong>STEPP</strong> device.<br />
� The SMS command including the parameter [PWD] has to be used, if<br />
the parameter [PWD] is already specified, otherwise the device will not<br />
accept <strong>commands</strong> without entering that password.<br />
� The SMS command excluding [PWD] parameter can be used, if the<br />
[PWD] parameter is empty (not specified from the user).<br />
All SMS <strong>commands</strong> have to be sent in uppercase (capital letter), otherwise, the<br />
configuration could not be accepted. If a sent command (via SMS, data<br />
connection or locally) is incorrectly typed (based on the structure in table<br />
below) by the user, the device ignores (refuses) that command and no<br />
configuration is per<strong>for</strong>med or you may carry the <strong>STEPP</strong> device into the<br />
instability conditions.<br />
If more than one parameter (combining <strong>commands</strong> on the same writable<br />
command line) should be sent within a command (SMS message), they should<br />
be separated by colons “:” (indicated as [:]). The square brackets have to be<br />
omitted when you input that command.<br />
IIf a command (message including one of the parameter name<br />
) is sent without value then the corrent status (value) of that<br />
parameter stored into the FLASH memory will be deleted (deactivated), except<br />
the “&REQCNF” read command.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 73