6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
SMS<br />
command<br />
NMEA<br />
message<br />
:<br />
It defines the maximum value be<strong>for</strong>e analog input triggered.<br />
:<br />
It defines the input NMEA messages (see chapter 6.2), which will be<br />
sent to the message sender, only if the alarm type is set to S<br />
(<strong>for</strong> SMS).<br />
How the parameter could be sent:<br />
&CNF UNIT IN1=S0123456,alarm in analogue input 1,2,4,IOP<br />
&CNF UNIT IN2=S0123456,alarm in analogue input 1,3,5,IOP<br />
&CNF UNIT IN2<br />
$PSRF108,IN1=S0123456,alarm in analogue input 1,2,4,IOP*14<br />
$PSRF108,IN2=S0123434,alarm in analogue input 2,3,5,IOP*10<br />
$PSRF108,IN2*37<br />
Notes<br />
• If an analogue input has already been configured, each other SMS<br />
command sent to the device overwrites the existing configuration.<br />
• If an imput is configured to establish a voice or a data call the context<br />
of and fields can be removed (not required to be<br />
set).<br />
• If the <strong>STEPP</strong> device is configured to establish a voice or a data call to<br />
target phone number and the target phone/mobile is switched off or it is<br />
already not registered in the GSM network, the <strong>STEPP</strong> device tries upto<br />
3 time to reach that phone number. In case of unsuccessfully<br />
connection, the <strong>STEPP</strong> ignores it.<br />
• If more then one phone number is specified in field and the <strong>STEPP</strong> device is configured to establish a<br />
Voice or a Data call to target phone numbers, then the <strong>STEPP</strong> tries upto<br />
3 time to reach one of the specified phone numbers.<br />
• To delete the present configuration of an analogue input, a SMS<br />
message without value has to be sent to the device.<br />
6.3.8 TEL<br />
Syntax TEL=<br />
This parameter allows you to determine the index in the authorized list<br />
where the phone number has to be saved.<br />
<br />
It specifies the entry index of list from 0 to 9 to save the given<br />
number.<br />
:<br />
It specifies the alarm type. It can be set to S, D, V or A corresponding<br />
to an SMS, Data call, Voice call or Alarm (listen-in mode) call<br />
respectively; see also sections 4.3.9.1 and 4.3.9.2.<br />
<br />
It determines the authorized network numbers. The specified phone<br />
number(s) may also be called “device administrator(s)”<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 88