6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
4. Connect the AMP 15-pin plug connector with the 15-pin AMP connection<br />
point on <strong>Falcom</strong> <strong>STEPP</strong>.<br />
5. Connect the 15-pin serial plug with the 15-pin COM port of the EVAL-<br />
BOARD.<br />
The green LED at the RJ45 connection will begin to glow.<br />
This LED signals the tension of <strong>Falcom</strong> <strong>STEPP</strong>’s internal storage battery.<br />
6. Connect the 16-pin plug connector to the 16-pin MOLEX connection<br />
point on <strong>Falcom</strong> <strong>STEPP</strong>.<br />
7. Connect the other end of the MOLEX cable with the 16-pin MOLEX<br />
connection point on the EVAL-BOARD.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 14