6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
Important<br />
Upon receiving a configuration SMS, <strong>Falcom</strong> <strong>STEPP</strong> will acknowledge<br />
the receipt to you via SMS. The SMS will contain status in<strong>for</strong>mation <strong>for</strong><br />
the receipt of the SMS configuration.<br />
Example:<br />
+CMT: , ,<br />
• Status: OK – Command received correctly<br />
• Status: bad command – faulty command received<br />
• Status: bad password – wrong password given<br />
4.3.2.3 Examples of configuration <strong>commands</strong><br />
Please note: If the configuration of the <strong>Falcom</strong> <strong>STEPP</strong> contains no password,<br />
the parameter can be omitted.<br />
The <strong>commands</strong> are sent via SMS to the vehicle, which is to be<br />
configured.<br />
&CNF PORT1 Z,1,1<br />
− Switches on port 1, flashes in intervals, 1 sec. ON, 1 sec. OFF<br />
&CNF PORT1 A<br />
− Switches off port 1<br />
&CNF PORT1 E<br />
− Switches on port 1<br />
&CNF KEY1 S01234567,Alarm Input 1,RMC<br />
− In case of an alarm on input 1, a SMS will be sent to the telephone<br />
number 01234567, with an attached GPS position message ($GPRMC<br />
protocol)<br />
&CNF NAME MyCar<br />
− the vehicle has the name “MyCar”<br />
&CNF PASS NewPass<br />
− the password <strong>for</strong> future configurations has been set to “NewPass”<br />
In chapter 4.2.1 SMS <strong>commands</strong>, you will find a complete list of all SMS<br />
<strong>commands</strong>.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 54