6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
calculate a valid position due to the failure of satellites in view (less then 3<br />
satellites or other conditions). This procedure repeats itself until the valid<br />
position computation (a GPS-fix) of GPS receiver is completed.<br />
<br />
It specifies the number of minutes to reset the GPS core. The is<br />
an integer value, and its unit is minute.<br />
<br />
It specifies the startup-mode of integerated GPS receiver in the <strong>STEPP</strong><br />
device. The GPS receiver can manually be initiated to one of three<br />
different start up modes specified in the . In order to<br />
per<strong>for</strong>m one of three different start up modes the can be<br />
set to C, W or H corresponding to Cold, Warm or Hot start respectively.<br />
The default setting of startup procedure is set to H corresponding to the<br />
Hot start with a period of time of 10 minutes.<br />
How the parameter could be sent:<br />
SMS &CNF PWD UNIT GPSRESET<br />
command<br />
(c) =10<br />
&CNF PWD UNIT GPSRESET (g) =10,C<br />
NMEA $PSRF108,GPSRESET=10*2F<br />
message $PSRF108,GPSRESET=10,C*40<br />
Notes<br />
• After each GPS reset, a SMS message including the GPS position may<br />
be delivered from the device, if the user-defined configuration in the<br />
MSG or GEOMSG parameter is exceeded. The SMS message will be<br />
sent to the user-specified phone number in the or<br />
field respectively.<br />
• The GPS part resets itself (makes a hot start) every 10 minutes if no<br />
configuration is per<strong>for</strong>med (= default setting) and if no GPS fix is<br />
obtained. The <strong>STEPP</strong> operating with firmware 1.6.2 and earlier<br />
versions per<strong>for</strong>mes Cold starts, only.<br />
• Please not that, the new parameter is supported by the<br />
firmware 1.6.5 and greater versions, only.<br />
6.3.13 GSMRESET (c)<br />
Syntax GSMRESET=<br />
This parameter allows the <strong>STEPP</strong> device to reset the GSM core (in user<br />
defined interval of time).<br />
<br />
Indicates the set time of reset. The is an integer value, and its<br />
unit is in minute.<br />
How the parameter could be sent:<br />
c<br />
The Firmware 1.4 and greater versions support this parameter.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 92
Change language