6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
6.3.16 IGN (f)<br />
device location and/or device events (depending on the user-specified<br />
protocol(s)). This feature can be enabled from the device manager (one<br />
of the authorized phone numbers, if specified), without the need to<br />
enter the phone numbers of these participants in the authorized list. In<br />
this way the participants could not access the <strong>STEPP</strong> device. This<br />
feature can also be called “alarm <strong>for</strong>warding”.<br />
Syntax IGN=,,<br />
This execute parameter has to be per<strong>for</strong>med by monitoring an abandoned<br />
vehicle fitted with <strong>Falcom</strong> <strong>STEPP</strong>. Unimportant how the Ignition stauts is. By<br />
sending this command, the <strong>STEPP</strong> device generate automatically a Master<br />
region (GEO00) of a given value. The center of generated Master<br />
region is the current <strong>STEPP</strong> position. If the wehicle goes out of this Master<br />
region and the IGN signal is switched off, an alarm will be sent out to the predefined<br />
phone number. As long as the IGN signal is turned on, the generated<br />
Master region (GEO00) will be deleted, so there is no more vehicle monitoring<br />
available. But if the IGN signal will be switched off again, the <strong>STEPP</strong> device<br />
generates automatically the new Master region (GEO00) of existing <br />
value. The center of generated Master region will be the current <strong>STEPP</strong><br />
position.<br />
Please note that, this cofiguration has more priority than &CNF [PWD]<br />
WATCH cofiguration. That means, if a Master region is already per<strong>for</strong>med via<br />
&CNF WATCH command and the user per<strong>for</strong>ms a new one via &CNF UNIT<br />
IGN, then the &CNF WATCH configuration will exists as long as the Ignition<br />
does not alert its state. If Ignition alerts its state from ON to OFF, the &CNF<br />
WATCH configuration will be overwritten by &CNF UNIT IGN<br />
configuration.<br />
<br />
Not supported by the firmware. It can be set to zero (0).<br />
<br />
Optional positive number, unit is meter. Place the vehicle into a restricted<br />
circle zone, whereby the current position (including Latitude and<br />
Longitude) of the <strong>STEPP</strong> is the center of circle and is the<br />
radius of circle.<br />
<br />
String, the SMS message which will be delivered from the <strong>STEPP</strong> device<br />
to the target phone number specified by the GEOMSG<br />
parameter. This parameter is optional, up to 20 character can be set.<br />
How the parameter could be sent:<br />
f<br />
The Firmware 1.6 and greater versions support this parameter.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 95