Tooling Systems

ModBORE Boring Systems
DV SYSTEM
QC / R8 SYSTEMS
STRAIGHT SHANK
COLLETS / SLEEVES
INDEX TECHNICAL ACCESSORIES
CV SYSTEM
BT SYSTEM
HSK SYSTEM
KM SYSTEM
Single-Point Cutters for Fine Boring — with KM Connection
Diameters from .945" to 6.024" (24mm to 153mm).
Standard Inserts
The ModBORE system uses industry-standard carbide to assist in reducing tool inventories.
Inserts are available in a wide variety of high-performance Kennametal grades,
coatings, and chip-control geometries to handle your specific machining applications.
Build to Length
Increase boring reach with KM extensions or reducers to customize the tool to meet your specific requirements.
Limited Component Requirements
Seven tools cover the entire product range.
Through-Coolant
Use of coolant improves tool life and surface finish, and promotes chip evacuation.
All KM ModBORE tooling provides through coolant.
Accurate Adjustment
Precision-ground micrometric screw enables fine adjustment for diameter settings.
The adjustment is free from backlash and play. Each division indicator
on the dial equals .0004" (0,01mm) on diameter.
Strong Locking Mechanism
Diameter setting does not change when tool is “locked-in” for operation.
Bore size stays consistent even at high RPMs.
Optimum Cutting Geometry
Inserts are located on tool centerline for accurate adjustment and performance.
Limited Hardware Requirements
Five different sizes of spare insert holders accommodate seven fine-boring tools.
188
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com.