Tooling Systems

Balanced-by-design.
1" - 8 UNC drawbar thread.
Runout ≤0,003mm (.0001").
Through-the-toolholder coolant capability
— form AD or form B.
10mm (3/8") axial adjustment stop through
center of tool.
CV 50 Shank Tools
Hydraulic Chucks — Basic Line
KM SYSTEM
HSK SYSTEM
HC Basic-CV form B/AD — Metric
order number catalog number D1 D2 L1 L2 L9 V kg
actuation & stop
screw wrench
wrench sizeactuation
screw
wrench sizestop
screw
2001977 CV50BHCB20M400 20 63 101,6 65 41 10 4,38 170.135 5 MM 5 MM
BT SYSTEM
HC Basic-CV form B/AD — Inch
order number catalog number D1 D2 L1 L2 L9 V lbs.
actuation & stopscrew
wrench
wrench sizeactuation
screw
wrench size-stop
screw
2001978 CV50BHCB075400 3/4 2.47 4.00 2.56 1.61 .39 9.68 170.135 5 MM 5 MM
IMPORTANT: Do not overtorque clamp screw. Use supplied wrench and tighten by hand until stop is felt.
Hydraulic chuck technical section, see page 805.
Supplied with stop screw and actuation wrench (in some cases these are the same wrench).
Unable to use SEFAS chamfering rings on this design.
Reduction sleeves are available and must be ordered separately; see page 643.
For retention knobs, see page 764.
Toolholders are factory set to the
form B coolant supply position.
When relocating coolant position
screws, use of a removable liquid
(small screw thread locker)
is recommended.
The toolholder can be easily converted
to DIN 69871 form AD coolant supply;
tightening screws will stop coolant
from escaping through the flange.
CV SYSTEM
DV SYSTEM
QC / R8 SYSTEMS
INDEX TECHNICAL ACCESSORIES
COLLETS / SLEEVES
STRAIGHT SHANK
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com. 537