Tooling Systems

STRAIGHT SHANK QC / R8 SYSTEMS DV SYSTEM
CV SYSTEM
BT SYSTEM
HSK SYSTEM KM SYSTEM
CV 40 Shank Tools
DA 08 Series — Double-Angle Collet Chucks
Grip 1:1.
Balanced-by-design.
5/8" - 11 UNC drawbar thread.
Through-the-toolholder coolant capability
— form AD.
Collet Capacity
mm inch
DA - 08 Collet Series min. max. min. max.
DA200 0,2 10 1/64 25/64
DA180 2,2 20 1/64 3/4
DA-CV form AD — Hex Locknut
order number catalog number collet series D11 L1 L9 V lbs. locknut
locknut
wrench ft.lbs
stop
screw
wrench sizestop
screw
1015515 CV40DA208300 DA200 1.15 3.00 1.62 1.38 2.41 NPA208 OEW100 40 SS044038G 4 MM & 5/32
1015305 CV40DA208500 DA200 1.15 5.00 1.62 3.38 3.05 NPA208 OEW100 40 SS044038G 4 MM & 5/32
1015596 CV40DA188300 DA180 1.73 3.00 1.94 .81 2.42 NPA188 OEW150 75 SS081041G 4 MM & 5/32
1015304 CV40DA188600 DA180 1.73 6.00 1.94 3.94 3.60 NPA188 OEW150 75 SS081041G 4 MM & 5/32
Tighten locknut to the recommended tightening torque.
Collet chuck technical section, see page 816.
Supplied with locknut and stop screw.
Locknut wrench must be ordered separately.
Stop screw coolant caps are available and must be ordered separately; see page 757.
DA standard straight-bore collets, see page 713.
DA non-pullout collets, see page 713.
For retention knobs, see page 764.
Drill Chucks
Through-the-toolholder coolant capability.
5/8" - 11 UNC drawbar thread.
COLLETS / SLEEVES
INDEX TECHNICAL ACCESSORIES
DC-CV form A
D1
D1 max.
order number catalog number mm inch mm inch D2 L1 L1S lbs. ft.lbs
2262967 CV40DC13M421 1,0 .039 13,0 .512 1.97 4.21 3.78 3.38 40
Tighten to the recommended tightening torque.
Locking wrench supplied; order number is HSW45M.
For retention knobs, see page 764.
520
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com.