Tooling Systems

BT 40 Shank Tools
Hydraulic Chucks — Slim Line (continued)
HSK SYSTEM
KM SYSTEM
HC Slim-BT form B/AD — Metric
Spare Parts
(continued from previous page)
order number catalog number D1 D2 D21 L1 L2 L9 V kg
2634575 BT40BHCSL12170M 12 19,5 44,5 170 95 36 10 1,61
2634576 BT40BHCSL14170M 14 21,5 52,5 170 95 36 10 1,84
2634577 BT40BHCSL16170M 16 23,5 52,5 170 95 39 10 1,87
2634578 BT40BHCSL18170M 18 25,5 52,5 170 95 39 10 1,91
2634579 BT40BHCSL20170M 20 27,5 52,5 170 95 41 10 1,95
BT SYSTEM
CV SYSTEM
catalog number
actuation
wrench
wrench sizeactuation
screw
stop screw
wrench
wrench sizestop
screw
BT40BHCSL12170M 170.135 5 MM 170.002 2.5 MM
BT40BHCSL14170M 170.135 5 MM 170.002 2.5 MM
BT40BHCSL16170M 170.135 5 MM 170.002 2.5 MM
BT40BHCSL18170M 170.135 5 MM 170.002 2.5 MM
BT40BHCSL20170M 170.135 5 MM 170.002 2.5 MM
IMPORTANT: Do not overtorque clamp screw. Use supplied wrench and tighten by hand until stop is felt.
Hydraulic chuck technical section, see page 805.
Supplied with stop screw and actuation wrench (in some cases these are the same wrench).
Unable to use SEFAS chamfering rings on this design.
Reduction sleeves are available and must be ordered separately; see page 643.
For retention knobs, see page 764.
Toolholders are factory set to the
form B coolant supply position.
When relocating coolant position
screws, use of a removable liquid
(small screw thread locker)
is recommended.
The toolholder can be easily converted
to DIN 69871 form AD coolant supply;
tightening screws will stop coolant
from escaping through the flange.
COLLETS / SLEEVES STRAIGHT SHANK QC / R8 SYSTEMS DV SYSTEM
INDEX TECHNICAL ACCESSORIES
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com. 455