Tooling Systems

DV 50 Shank Tools
Hydraulic Chucks — Slim Line (continued)
INDEX TECHNICAL ACCESSORIES
HSK SYSTEM
BT SYSTEM
CV SYSTEM
COLLETS / SLEEVES STRAIGHT SHANK QC / R8 SYSTEMS DV SYSTEM
KM SYSTEM
HC Slim-DV form B/AD — Metric
(continued from previous page)
order number catalog number D1 D2 D21 L1 L2 L9 V kg
2634420 DV50BHCSL12200M 12 19,5 44,5 200 95 36 10 3,58
2634421 DV50BHCSL14200M 14 21,5 52,5 200 95 36 10 3,99
2634422 DV50BHCSL16200M 16 23,5 52,5 200 95 39 10 4,01
2634533 DV50BHCSL18200M 18 25,5 52,5 200 95 39 10 4,05
2634534 DV50BHCSL20200M 20 27,5 52,5 200 95 41 10 4,09
Spare Parts
catalog number
actuation
wrench
wrench sizeactuation
screw
stop screw
wrench
wrench sizestop
screw
DV50BHCSL12200M 170.135 5 MM 170.002 2.5 MM
DV50BHCSL14200M 170.135 5 MM 170.002 2.5 MM
DV50BHCSL16200M 170.135 5 MM 170.002 2.5 MM
DV50BHCSL18200M 170.135 5 MM 170.002 2.5 MM
DV50BHCSL20200M 170.135 5 MM 170.002 2.5 MM
IMPORTANT: Do not overtorque clamp screw. Use supplied wrench and tighten by hand until stop is felt.
Hydraulic chuck technical section, see page 805.
Supplied with stop screw and actuation wrench (in some cases these are the same wrench).
Unable to use SEFAS chamfering rings on this design.
Reduction sleeves are available and must be ordered separately; see page 643.
For retention knobs, see page 764.
Toolholders are factory set to the
form B coolant supply position.
When relocating coolant position
screws, use of a removable liquid
(small screw thread locker)
is recommended.
The toolholder can be easily converted
to DIN 69871 form AD coolant supply;
tightening screws will stop coolant
from escaping through the flange.
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com. 585