Tooling Systems

Collets and Sleeves
3/4" SMC Milling Chuck Sleeves
KM SYSTEM
One-piece design.
Cutting tool must be cylindrical.
Sleeve must be inserted completely into
the milling chuck until shoulder mates
against the chuck front face.
Cutting tools must be in full contact with
the sleeve bore length (L9).
Cutting tool shank requirement tolerance is
h6 and Ra ≥ 0,3 µm (12 µ in) surface finish.
Metric and inch bores are available.
HSK SYSTEM
BT SYSTEM
SMC750 Sleeve — Metric
(3/4" sleeve with metric bores)
D1 order number catalog number
sleeve
series
sleeve capacity
max. mm
sleeve capacity
min. mm
L9
6,0 3101080 75SMC060M SM750 6,000 5,992 32
8,0 3101081 75SMC080M SM750 8,000 7,991 35
10,0 3101082 75SMC100M SM750 10,000 9,991 36
12,0 3101083 75SMC120M SM750 12,000 11,989 40
14,0 3101084 75SMC140M SM750 14,000 13,989 41
16,0 3101085 75SMC160M SM750 16,000 15,989 41
CV SYSTEM
DV SYSTEM
SMC750 Sleeve — Inch
(3/4" sleeve with inch bores)
D1 order number catalog number
sleeve
series
sleeve capacity
max. inch
sleeve capacity
min. inch
L9
1/8 3101010 75SMC0125 SM750 .1250 .1246 .709
3/16 3101073 75SMC0188 SM750 .1875 .1871 .984
1/4 3101012 75SMC0250 SM750 .2500 .2496 1.260
5/16 3101074 75SMC0312 SM750 .3125 .3121 1.378
3/8 3101075 75SMC0375 SM750 .3750 .3746 1.417
7/16 3101076 75SMC0438 SM750 .4375 .4371 1.575
1/2 3101077 75SMC0500 SM750 .5000 .4996 1.575
9/16 3101078 75SMC0563 SM750 .5625 .5621 1.614
5/8 3101079 75SMC0625 SM750 .6250 .6246 1.614
QC / R8 SYSTEMS
STRAIGHT SHANK
COLLETS / SLEEVES
INDEX TECHNICAL ACCESSORIES
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com. 653