Tooling Systems

KM50 Shank Tools
Drill Chucks
KM SYSTEM
Drill Chucks
D1 = 2,5 mm - 16 mm range
D1 = .098" - .630" range
RDC — Drill Chucks
D2
L1S
order number catalog number mm inch mm inch
1136057 KM50RDC16108 56 2.20 103,3 4.067
Activation size is 6 mm.
Activation wrench is included.
Wrench re-order number is
HSK SYSTEM
BT SYSTEM
DV SYSTEM
CV SYSTEM
TG Flush Face Locknut Coolant Cap Accessory
NEW!
Upgrade to a sealed coolant cap!
Use the new Flush Face locknut coolant cap
assembly accessory with standard ER coolant
disks to create a sealed unit without the use
of bonded collets.
Convert to this locknut system from any
existing Kennametal TG collet system to avoid
collet chip packing and ensure an adequate
through-coolant seal.
Advanced features!
• Use with high-pressure coolant up to 1,500
PSI (103 bar).
• Use standard TG collets and ER coolant disks.
• More effective than bonded collets.
• Seal against chip packing and machined
contaminates in collet slots and locknuts.
INDEX TECHNICAL ACCESSORIES COLLETS / SLEEVES STRAIGHT SHANK QC / R8 SYSTEMS
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com. 243