Tooling Systems

DV SYSTEM
CV SYSTEM
BT SYSTEM
HSK SYSTEM KM SYSTEM
DV 50 Shank Tools
DA 08 Series — Double-Angle Collet Chucks
Grip (1:1).
Balanced-by-design.
Through-the-toolholder coolant
capability — form AD or form B.
Collet Capacity
mm inch
DA - 08 Collet Series min. max. min. max.
DA180 2,2 20 1/64 3/4
DA-DV form B/AD — Round Locknut
order number catalog number collet series D11 L1 L9 V kg locknut
locknut
wrench Nm
stop
screw
wrench sizestop
screw
1264080 DV50BDA188150M DA180 43 150 50 50 3,50 LNA188M HSW45M 136 SS081041G 4 MM & 5/32
Tighten locknut to the recommended tightening torque.
Collet chuck technical section, see page 816.
Supplied with locknut and stop screw.
Locknut wrench must be ordered separately.
Stop screw coolant caps are available and must be ordered separately; see page 757.
DA standard straight-bore collets, see page 713.
DA non-pullout collets, see page 713.
For retention knobs, see page 764.
QC / R8 SYSTEMS
Toolholders are factory set to the
form B coolant supply position.
When relocating coolant position
screws, use of a removable liquid
(small screw thread locker)
is recommended.
The toolholder can be easily converted
to DIN 69871 form AD coolant supply;
tightening screws will stop coolant
from escaping through the flange.
INDEX TECHNICAL ACCESSORIES
COLLETS / SLEEVES
STRAIGHT SHANK
592
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com.