Tooling Systems

KM SYSTEM
HSK SYSTEM
HSK 100A Shank Tools
Hydraulic Chucks — Trend Line — Metric
Pre-balanced G2.5 @ 15,000 rpm.
Runout ≤0,003mm (.0001").
Through-the-toolholder coolant capability.
10mm (3/8") axial adjustment stop through
center of tool.
HC Trend-HSK form A — Metric
QC / R8 SYSTEMS DV SYSTEM
CV SYSTEM
BT SYSTEM
order number catalog number D1 D2 D21 L1 L2 L9 V kg
actuation
wrench
wrench sizeactuation
screw
stop screw
wrench
wrench sizestop
screw
1749601 HSK100AHCT06085M 6 25,7 63 85 29 27 10 3 170.135 5 MM 170.003 3 MM
1749602 HSK100AHCT08085M 8 27,7 63 85 30 27 10 3 170.135 5 MM 170.003 3 MM
1749603 HSK100AHCT10090M 10 29,7 63 90 35 31 10 3 170.135 5 MM 170.003 3 MM
1749604 HSK100AHCT12095M 12 31,6 63 95 40 36 10 3 170.135 5 MM 170.003 3 MM
1749605 HSK100AHCT14095M 14 33,6 63 95 42 36 10 3 170.135 5 MM 170.135 5 MM
1749606 HSK100AHCT16100M 16 37,6 63 100 48 39 10 3 170.135 5 MM 170.135 5 MM
1749608 HSK100AHCT18100M 18 39,6 63 100 48 39 10 3 170.135 5 MM 170.135 5 MM
1749609 HSK100AHCT20105M 20 41,6 63 105 54 41 10 3 170.135 5 MM 170.135 5 MM
1749611 HSK100AHCT25115M 25 49,8 63 115 51 47 10 3 170.136 6 MM 170.005 5 MM
1749612 HSK100AHCT32120M 32 59,8 63 120 59 51 10 4 170.136 6 MM 170.005 5 MM
IMPORTANT: Do not overtorque actuation screw. Use supplied wrench and tighten by hand until stop is felt.
Hydraulic chuck technical section, see page 805.
Supplied with stop screw and actuation wrench.
SEFAS chamfering rings cannot be used on the slim-style hydraulic chucks.
Reduction sleeves are available and must be ordered separately; see page 643.
HSK coolant unit and wrench are available and must be ordered separately; see page 763.
STRAIGHT SHANK
COLLETS / SLEEVES
Tool Tips:
INDEX TECHNICAL ACCESSORIES
HSK Styles and Sizes:
Do you know your HSK tool configuration?
Refer to the beginning of the HSK section and review the
selection guide.
400
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com.