Tooling Systems

KM SYSTEM
CV Shank Tools
Kennametal Standard Catalog Number System
Special Feature (Optional)
DV SYSTEM
CV SYSTEM
BT SYSTEM
HSK SYSTEM
Shank
Taper Size
40 = 40
50 = 50
B =
Z =
(blank) =
CH =
DIN form B coolant feature (design allows
conversioin back to form A/AD style)
deviates from ANSI - B5-50 standard
- no hub in front of V flange
(no "B" or "Z") - tool built to
DIN form A/AD coolant style
coolant form AD - High Pressure
M = tool built to metric
values and has metric
retention thread
(blank) = tool built to inch
values and has inch
retention thread
CV 40 B TG 50 M 100 M
Shank
Style
Identification Values
Tool Length
(taper gage line to front of tool)
metric - xxx = xxx,
inch - xxx = x.xx
QC / R8 SYSTEMS
STRAIGHT SHANK
COLLETS / SLEEVES
INDEX TECHNICAL ACCESSORIES
Toolholder Style
BB = Bar blank
DA = Double-angle collet chuck
DC = Drill chuck
EM = End mill adapter
ER = DIN 6499 single-angle collet chuck
HC = Hydraulic chuck - STANDARD Line
HCB = Hydraulic chuck - BASIC Line
HCSL = Hydraulic chuck - SLIM Line
HCSLT = Hydraulic chuck - SLIM Line - Trend
HCT = Hydraulic chuck - TREND Line
HPMC = Milling chuck - high performance
HSK = HSK adapter
JT = Jacobs taper adapter
KM = KM adapter
KR = Kennametal/Romicron TM adapter
MT = Morse taper adapter
RC = Rapid change - T&C tapping adapter chuck
SA = Slotting cutter adapter
SER = DIN 6499 single-angle collet chuck - short with internal locknut
SM = Shell mill adapter
SS = Adapter for straight shanks (drills)
SSF = Adapter for straight shanks with flat (drills)
STRC = Rapid change - solid tapping adapter chuck
SWN = Whistle Notch 2° - short - (not to DIN standard)
TA = Tap chuck adapter
TCRC = Rapid change - tension and compression
TG = Tremendous Grip single-angle collet chuck
TGF = Tremendous Grip single-angle collet chuck - flush face
TT = Shrink Fit thermo toolholder
WN = Whistle Notch (2°, metric; 5°, inch)
Toolholder Size
Special
Feature
TG = collet series
xx (50), xxx (100)
EM = ID size:
metric — xx = xx, (20);
inch — xxx = x.xx (075)
SM = OD size:
metric - xx = xx, (20);
inch - xxx = x.xx (075)
M = previous 2/3 numbers are metric values
(this is an exception where there is a
metric bore on an inch shank style)
504
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com.