Tooling Systems

Grip 1:1.
Balanced-by-design.
Through-the-toolholder coolant capability —
form AD.
Collet Capacity
mm
inch
DA - 08 Collet Series min. max. min. max.
DA180 2,2 20 1/64 3/4
BT 50 Shank Tools
DA 08 Series Double-Angle Collet Chucks
KM SYSTEM
HSK SYSTEM
DA-BT form AD — Round Locknut
order number catalog number collet series D11 L1 L9 V kg locknut
locknut
wrench Nm stop screw
wrench sizestop
screw
1191767 BT50DA188070M DA180 43 70 50 47 3,70 LNA188M HSW45M 136 SS081041G 4 MM & 5/32
1197722 BT50DA188150M DA180 43 150 50 46 4,50 LNA188M HSW45M 136 SS081041G 4 MM & 5/32
1258441 BT50DA188200M DA180 43 200 50 46 5,00 LNA188M HSW45M 136 SS081041G 4 MM & 5/32
Tighten locknut to the recommended tightening torque.
Collet chuck technical section, see page 816.
Supplied with locknut and stop screw.
Locknut wrench must be ordered separately.
Stop screw coolant caps are available and must be ordered separately; see page 757.
DA standard straight-bore collets, see page 713.
DA non-pullout collets, see page 713.
For retention knobs, see page 764.
BT SYSTEM
CV SYSTEM
DV SYSTEM
Through-the-toolholder coolant capability.
Drill Chucks
QC / R8 SYSTEMS
STRAIGHT SHANK
DC-BT form A
D1
D1max
order number catalog number mm inch mm inch D2 L1 L1S
1131734 BT50REX1396M 1,0 13,0 43 114,5 106,5
1131738 BT50REX16112M 2,5 16,0 56 130,5 125,5
Tighten to the recommended tightening torque.
4mm locking wrench not supplied, catalog order number 170.304.
For retention knobs, see page 764.
COLLETS / SLEEVES
INDEX TECHNICAL ACCESSORIES
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com. 489