Tooling Systems

DV SYSTEM
CV SYSTEM
BT SYSTEM
HSK SYSTEM KM SYSTEM
CV 50 Shank Tools
DA 08 Series Double-Angle Collet Chucks
Grip 1:1.
Balanced-by-design.
1" - 8 UNC drawbar thread.
Through-the-toolholder coolant capability
— form AD.
Collet Capacity
mm
inch
DA 180 Collet Series min. max. min. max.
DA180 2,2 20 1/64 3/4
DA-CV form AD — Hex Locknut
order number catalog number collet series D11 L1 L9 V lbs. locknut
locknut
wrench ft.lbs stop screw
wrench sizestop
screw
1015306 CV50DA188300 DA180 1.73 3.00 1.93 2.36 7.03 NPA188 OEW150 75 SS081041G 4 MM & 5/32
1015307 CV50DA188600 DA180 1.73 6.00 1.93 4.65 8.21 NPA188 OEW150 75 SS081041G 4 MM & 5/32
Tighten locknut to the recommended tightening torque.
Collet chuck technical section, see page 816.
Supplied with locknut and stop screw.
Locknut wrench must be ordered separately.
Stop screw coolant caps are available and must be ordered separately; see page 757.
DA standard straight-bore collets, see page 713.
DA non-pullout collets, see page 713.
For retention knobs, see page 764.
QC / R8 SYSTEMS
Drill Chucks
Through-the-toolholder coolant capability.
1" - 8 UNC drawbar thread.
STRAIGHT SHANK
COLLETS / SLEEVES
DC-CV - form A
D1
D1 max
order number catalog number mm inch mm inch D2 L1 L1S lbs. ft.lbs
2262968 CV50DC13M421 1,0 .039 13,0 .512 1.97 4.21 3.78 8.01 40
Tighten to the recommended tightening torque.
Locking wrench supplied (catalog re-ordering number HSW45M).
For retention knobs, see page 764.
INDEX TECHNICAL ACCESSORIES
546
To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com.