C•CURE 800/8000 Hardware Configuration Guide - Tyco Security ...

Configuring ReadersTable 4-1: Reader Dialog Box Fields, continuedBox Field DescriptionSupervised InputsOutputsClick the check boxes beside these fields to configure thesupervised inputs that are on this reader. You can configure up to2 supervised inputs per reader. See “Configuring Inputs” onpage 5-2 for an explanation of input configuration tasks.Click the check boxes next to these fields to configure outputsthat are attached to this reader. You can configure up to 2 outputsper RM reader and 1 output per MRM reader. See “ConfiguringOutputs” on page 5-13 for an explanation of output configurationtasks. For each output connected to a reader, you need anAuxiliary Relay Module (ARM).See the iSTAR Pro or iSTAR eX Installation and ConfigurationGuide or the apC/8X or apC/L Installation and ConfigurationGuide for details.5. Click the Keypad button to open the Reader keypad configuration dialogbox where you specify PIN options for this reader. See “ConfiguringReader Keypad Options” on page 4-7 in this chapter for moreinformation.6. Click the Advanced button to open the Advanced reader configurationdialog box. There are different versions of this dialog box dependingupon whether the reader is on an iSTAR controller or an apC. See“Configuring Advanced Options for Readers on Controllers” onpage 4-11 and “Configuring Advanced Options for Readers on apCs” onpage 4-14 in this chapter for more information.7. Click OK.4–6 C•CURE 800/8000 Hardware Configuration Guide