C•CURE 800/8000 Hardware Configuration Guide - Tyco Security ...

Configuration Overview for iSTAR Classic & iSTAR ProConfiguration Overview for iSTAR Classic & iSTAR ProConfiguring the iSTAR controllers involves setting up the hardware andconfiguring the software components.NOTEBefore configuring a cluster, make sure you know each cluster member’sMAC address. The MAC address is built into the GCM and cannot bechanged.The Table 1-2 provides a list of tasks for software configuration of iSTARcontrollers.Table 1-2: Software Configuration TasksStage Task See...1 Use the Controller dialog box in the C•CURE 800/8000Administration application to configure iSTAR controllers.2 Use the Cluster dialog box in the C•CURE 800/8000Administration application to configure clusters.3 Use the iSTAR Configuration Utility to manually configure themaster.NOTE: After you configure the master, it reboots and thenestablishes a connection with the C•CURE System Host.The host downloads cardholder and configurationinformation to the master. The master uses thisinformation to auto-configure its cluster members.“Configuring iSTAR Classic & iSTAR ProControllers” on page 1-12 forinformation.“Configuring Clusters for iSTAR Classic& iSTAR Pro” on page 1-40 forinformation.iSTAR Pro Installation and ConfigurationGuide and/or iSTAR Installation andConfiguration Guide (Classic).C•CURE 800/8000 Hardware Configuration Guide 1–11