C•CURE 800/8000 Hardware Configuration Guide - Tyco Security ...

Configuring RM Reader LCD MessagesTable 4-9: Group 4 Tab FieldsTab Field DescriptionGroup 4 Keypad Command Prompt 1 Keypad Command Prompt 1 defaults to the message Enter AcsCode; it displays after the user enters the Command Code on theRM keypad and prompts the user to enter the second part of theidentifier for this keypad command (the access code). Thismessage is displayed for 15 seconds or until the user enters thecode.NOTE: This message does not display on the RM if you entered 0(zero) in the Maximum Length of Prompt 1 Code field onthe Keypad Commands tab in the System Variablesdialog box.Keypad Command Prompt 2Enter Next CardCMD IssuedKeypad Command Prompt 2 defaults to the message Enter TrgtCode; it displays after the user enters the Command Code (andpossibly the Prompt 1 Code) on the RM keypad and prompts theuser to enter the third part of the identifier for this keypadcommand (the target code). This message is displayed for 15seconds or until the user enters the code.NOTE: This message does not display on the RM if you entered 0(zero) in the Maximum Length of Prompt 1 Code field onthe Keypad Commands tab in the System Variablesdialog box.Enter Next Card indicates that an Escorted Visitor card has beenacknowledged by the door’s reader and prompts the nextEscorted Visitor or the Escort to present a card for access.NOTE: This message displays for Escorted Visitors or Escorts atdoors that permit multiple person access on each accesscycle.CMD Issued indicates that the keypad command entered on theRM Keypad was sent to the event manager. It does not indicatethat the event is active. This message is displayed for one secondafter the command is issued.C•CURE 800/8000 Hardware Configuration Guide 4–21