C•CURE 800/8000 Hardware Configuration Guide - Tyco Security ...

Configuring iSTAR Clusters for Dialup– After connection failure, controller attempts to reconnect every xxxxseconds field– While connected, declare connection failure if no message for xxseconds drop-down box• Controller activates this event while in connection failure field becomesavailable.NOTEThese procedures do not assume that you are configuring dialup for bothprimary and secondary communications paths—which is not permitted.The procedures merely illustrate that you configure dialup similarly forboth primary and secondary paths.7. In the Host activates this event while in connection failure field on thePrimary tab and in the Controller activates this event while in connectionfailure field on both the Primary and Secondary tabs, enter an optionalevent that activates when a communications failure occurs between thehost and the master. Double-click on the box to display a selectionbrowser for events. See page 1-45 for more information about configuringthe primary communications path and page 1-49 for more informationabout configuring the secondary communications path.8. Click the following on the Cluster dialog box to complete theconfiguration for the dialup cluster:• Dialup button on the Primary or Secondary tab to configure the Dialupcontroller. See “Configuring Dialup Options for iSTAR Clusters” onpage 10-12 for more information.• Cluster tab to configure communications among cluster members andthe master. See “Configuring Communications with the Master” onpage 1-53.• Misc tab to configure the test for the secondary communications path.See “Configuring the Secondary Communications Test” on page 1-56.• Global APB tab to configure antipassback for the cluster. See“Configuring Antipassback for the Cluster” on page 1-58.9. Click OK to save the dialup cluster configuration.C•CURE 800/8000 Hardware Configuration Guide 10–11