C•CURE 800/8000 Hardware Configuration Guide - Tyco Security ...

Configuring iSTAR Classic & iSTAR Pro ControllersTable 1-3: Controller Dialog Box Fields, continuedBox Field DescriptionHost activates this eventwhen controller is incommunication failure:Enter the name of the event that is activated when thiscontroller goes into communications failure. You can doubleclickon this field to open the Event Selection browser whereyou select, edit, or create an event.Specify an event that is located on the host. If the event islocated on a controller, the system displays an error message.NOTE: If this controller is a cluster member, the host activatesthe specified event any time the master goes intocommunications failure. The event is deactivated whencommunications are reestablished with the host usingeither the primary or secondary path.If this controller is a cluster member, the host activates thespecified event any time the master goes into communicationsfailure. The event is deactivated when communications arereestablished with the host using either the primary orsecondary path.Other TabsMain Board1st ACM1st ACM Ext2nd ACM2nd ACM ExtThis tab lets you configure the output and inputs on the GCMand RM LCD messages. See “Main Board Tab for iSTARClassic & iSTAR Pro” on page 1-20 for more information.This tab lets you configure inputs and outputs on the first ACM.“ACM and ACM Ext Tabs for iSTAR Classic & iSTAR Pro” onpage 1-23This tab lets you configure I/8 input modules, IR/8 outputmodules, and Readers on the first ACM attached to the GCM.“ACM and ACM Ext Tabs for iSTAR Classic & iSTAR Pro” onpage 1-23This tab lets you configure inputs and outputs on the secondACM attached to the GCM. “ACM and ACM Ext Tabs for iSTARClassic & iSTAR Pro” on page 1-23This tab lets you configure I/8 input modules, R/8 outputmodules, and Readers on the second ACM attached to theGCM. See “ACM and ACM Ext Tabs for iSTAR Classic &iSTAR Pro” on page 1-23 for more information.C•CURE 800/8000 Hardware Configuration Guide 1–17