C•CURE 800/8000 Hardware Configuration Guide - Tyco Security ...

R/8 — Output Modules3. Choose the output you want to add by clicking the appropriate check box.The system automatically configures the output using values from thedefault output definition and an assigned name.NOTETo edit the default output definition, choose Output from the Hardwaremenu and click the Edit Default button in the Output Selection browser.The Output dialog box opens.See “Configuring Outputs” on page 5-13 forinformation.If Online is the default setting for the output and you do not de-select thisoption, the output is set online and downloaded after you click OK in theapC dialog box.4. To view or edit the output, click the output’s View button. The Outputdialog box opens.5. Edit the output for the add-on board as you would any output on themain panel. See “Configuring Outputs” on page 5-13 for information.6. In the R/8 window, provide the information shown in Table 6-4 onpage 6-20 in the Events box and click OK.Table 6-4: R/8 Dialog Box FieldsBoxActivate this event while boardtamperedActivate this event duringcommunications failuresDescriptionEnter an event to activate when the board istampered.If this board is on a dialup panel, the event’sdialup setting determines whether the panel dialsthe host when the board is tampered. See“Setting Dialup Options for Events” in theC•CURE 800/8000 Software Configuration Guidefor more information.Enter an event to activate when there is acommunications failure between the board andthe panel.If this board is on a dialup panel, the event’sdialup setting determines whether the panel dialsthe host when a communications failure occurs.See “Setting Dialup Options for Events” in theC•CURE 800/8000 Software Configuration Guidefor more information.6–20 C•CURE 800/8000 Hardware Configuration Guide