C•CURE 800/8000 Hardware Configuration Guide - Tyco Security ...

Main Board TabMain Board TabConfiguring the Main BoardThe Main Board tab in the Controller dialog box lets you define Readers,Inputs and Outputs on the iSTAR eX and RM LCD messages for thecontroller. The options available for selection on the Main Board dialog boxare as follow:Special Purpose Inputs• Tamper input activates when the controller cabinet is opened or removedfrom its mounting surface.• AC power fail input monitors the AC power failure output of a batterybackup unit. When this alarm input activates, it specifies that the iSTAReX has lost its primary power source and is operating on batteries.• Low battery input activates when the emergency battery is running lowon power.Options Common to the Entire Panel• RM LCD messages specifies the set of RM Reader LCD messages toassign to the iSTAR eX controller.• Supervising resistor configuration The iSTAR eX can supervise witheither one or two resistors. These resistors can have one resistor with 5Kor 10K ohm resistivity and two resistors with 1K, 5K or 10K ohmresistivity.General Purpose Inputs• General Purpose Inputs 1 to Input 16 are automatically configured usingthe values from the default input definition. To view or edit the input,click the input’s View button.C•CURE 800/8000 Hardware Configuration Guide 2–19