C•CURE 800/8000 Hardware Configuration Guide - Tyco Security ...

Inputs OverviewInputs OverviewUse the following sections in this chapter to configure inputs. See Chapter 6,“Configuring Add-on Boards for apCs and iSTARs” for more information.NOTEInputs on the controller ACMs are supervised inputs. Unsupervisedinputs for the controller are located on the GCM. Inputs on the mainpanel, the WPSC, the I/8 - Input Module, and the I32 system input boardare supervised inputs. All inputs on the apC/L are supervised.Unsupervised inputs for the apC and apC/8X are located on the standardstar coupler.Configuring InputsWhen you configure the panel or ACM, you also need to configure inputs sothat the system can monitor the status of alarm devices.NOTEInputs on a controller/panel are associated with the time zone that isspecified for the controller/panel.To Configure Inputs Attached to this Controller/Panel1. From one of the following dialog boxes select the number of the input youwant to configure by clicking the appropriate check box:• 1st ACM or 2nd ACM tab in the Controller dialog box.• Panel Layout dialog box for the apC, apC/8X, or apC/LThe system automatically configures the input using the values from thedefault input definition and an assigned name.5–2 C•CURE 800/8000 Hardware Configuration Guide