C•CURE 800/8000 Hardware Configuration Guide - Tyco Security ...

Configuring Dialup Options for iSTAR ClustersTable 10-4: Periodic Tab FieldsBox Field DescriptionPeriodic dialPeriodic dial (cont)Redial interval duringcommunications failure:hh:mmTime specificationDial interval during timespecificationhh:mmDial interval outside timespecificationhh:mmEnter the interval of time the controller waits to redial the hostwhen there is a communications failure. Enter the time inhh:mm format. The default is 30 minutes.NOTE: The number that you enter in this field sets the lengthof time that the controller’s dialing process “goes tosleep” after attempting to reconnect to the host thenumber of times configured on the Dial In tab beforebeginning another cycle of connection attempts. See“Configuring Dial In Options for Dialup Controllers” onpage 10-13 for more information.Enter a time specification for periodic dialing of the host anduploading activity from the controller to the host anddownloading configuration changes and cardholderinformation from the host. The default value is $Always.Use Dial interval during time specification to specify howoften during this time specification the controller dials thehost; use the Dial interval outside time specification tospecify how often outside of this time specification thecontroller dials the host.Example:If you specify a time specification called Week (Mondaythrough Friday, 9 a.m. to 5 p.m.) and enter the followingvalues,• Interval between dialing during time specification:01:00• Interval between dialing outside time specification:03:00the controller dials the host every hour between thehours of 9 a.m. and 5 p.m., Monday through Friday; andevery three hours 5 p.m. to 9 a.m. Monday throughFriday, Saturday and Sunday.Enter the frequency that the controller dials the host while thetime specification is in effect. Enter the time in hh:mmformat. The time can be from 0 to 99:59 hours. The defaulttime is 1 hour.Enter the frequency that the controller dials the host while thetime specification is not in effect. Enter the time in hh:mmformat. The time can be from 0 to 99:59 hours. The defaulttime is 4 hours.10–18 C•CURE 800/8000 Hardware Configuration Guide