C•CURE 800/8000 Hardware Configuration Guide - Tyco Security ...

Configuring OutputsTable 5-4: Output Dialog Box Fields, continuedBox Field/Button DescriptionOptionsPulse duration1/10th sec.Send state changes of thisevent to monitoring stationSend state changes of thisevent to journalNormally energizedEnter a value in 1/10ths of a second for the time the output willremain active when it is pulsed.Displays the event in the Monitoring Station. Click Send statechanges of this event to monitoring station if you want the eventdisplayed in the Event Monitor, the General Activity Monitor todisplay a message, and the Journal to log a message when thisevent changes state.Neither the Event Monitor nor the General Activity Monitor willdisplay activation and deactivation for this event should you clearthis option. However, these event state changes will automaticallybe sent to the Journal unless both the Send state changes ofthis event to monitoring station and Send state changes ofthis event to journal options are cleared.Click Send state changes of this event to journal if you want thejournal to log a message when this event changes state.NOTE: Clicking this option is useful only if you have cleared theSend state changes to monitoring station option. Eventstate changes are automatically sent to the journal whenthe Send state changes to monitoring station option isselected. Changes in events that are not sent to theMonitoring Station or to the Journal are not tracked bythe systemClick this check box if the output is normally energized. Thismeans that the output is energized (power supplied to the relay)when it is inactive. When the output is activated, power isremoved.Other screens View Linkages Click this button to see the Output - linkages dialog box. See“Viewing Output Linkages” on page 5-16 for more information.C•CURE 800/8000 Hardware Configuration Guide 5–15