C•CURE 800/8000 Hardware Configuration Guide - Tyco Security ...

Configuring iSTAR Classic & iSTAR Pro ControllersConfiguring Holiday Lists for a ControllerNOTEThis section is applicable only if your C•CURE 800/8000 system isoperating in Distributed Holidays mode—enabled on the SystemVariables System tab.For more information about these modes and how to change them andHoliday Lists in general, see Chapter 11 “Holiday Lists” in the C•CURE800/8000 Software Configuration Guide and Chapter 1 “Setting SystemVariables” in the C•CURE 800/8000 System Maintenance Guide.You can download any holiday list to an iSTAR controller from a dialog boxaccessed either from the General tab, or alternatively, from the Holiday ListConfiguration dialog box.A Holiday List downloaded to an iSTAR controller acts as an override toprevent activation of normally scheduled clearances and timed-based eventson the Holidays defined in the Holiday List. You can configure up to 24holiday lists for each iSTAR controller.To Select Holiday Lists for the Controller1. On the General tab of the Controller dialog box, click the Holiday Listsbutton.The Select Holiday Lists dialog box opens, as shown in Figure 1-7 onpage 1-19.1–18 C•CURE 800/8000 Hardware Configuration Guide