ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

More documents

Recommendations

Info

ARMY TM 9-6115-464-34AIR FORCE TO 35C2-3-445-2NAVY NAVFAC P-8-624-343-23. FUEL INJECTION NOZZLE HOLDERS AND LINES.a. Removal. Refer to the Operator and Unit Maintenance Manual for fuel injection nozzle holders and linesremoval instructions.b. Disassembly.(1) Unscrew spray cap (1, figure 3-25) and remove pintle holder (2) and pintle (3).(2) Remove cap (4) and washer (5).(3) Remove lock nut (6), adjusting screw (7), and washer (8) to remove spring (9) and spindle (10) frombody (11).c. Cleaning and Inspection.WARNINGSolvent, MIL-C-38736 is flammable and highly toxic to skin, eyes and respiratory tract.Eye and skin protection required. Good general ventilation is normally adequate.Failure to observe this warning could result in servere personal injury.(1) Soak nozzle holder parts in solvent, Methy Ethyl Ketone (MEK), and dry with a clean, lint-free cloth.(2) Soak nozzle holder parts in a container of clean fuel and dry with a clean, lint-free cloth.(3) Inspect pintle, pintle holder and spray cap for cracks, corrosion, erosion from fuel flow and otherdamage.(4) Check body, spindle, and cap for cracks, corrosion, breaks, and other damage.(5) Check spring for fretting, cracks, breaks, corrosion, and distortion.(6) Check all threaded parts for cross, stripped, or otherwise damaged threads.d. Repair. Repair nozzle holder by replacing defective parts.e. Assembly.(1) Install spindle (10, figure 3-25) and spring (9) into body (11).(2) Install washer (8), adjusting screw (7) and locknut (6).(3) Insert pintle (3) into pintle holder (2).(4) Position pintle holder in body and secure with spray cap (1).(5) Do not install washer (5) and cap (4) until after adjustment.f. Testing and Adjustment.(1) Install repaired nozzle holder on a standard static fuel nozzle testing fixture.(2) Tighten adjusting screw all the way down.(3) Apply fuel at 2500-2950 psig and slowly loosen adjusting screw until nozzle begins to open.(4) Tighten locknut while holding adjusting screw with screwdriver.(5) Lower fuel pressure. Nozzle holder assembly shall close.(6) Slowly increase fuel pressure. Nozzle holder shall open at 2500-2950 psig.3-66
ARMY TM 9-6115-464-34AIR FORCE TO 35C2-3-445-2NAVY NAVFAC P-8-624-34Figure 3-25. Fuel Injection Nozzle Holder, Exploded View(7) Observe fuel spray. Fuel spray shall be even and smooth. Spray cone shall be same thickness at adistance of 5 inches. There shall be no signs of leakage.(8) Remove fuel pressure and remove nozzle holder from testing fixture.(9) Install washer (5, figure 3-25) and cap (4).g. Installation. Refer to the Operator and Unit Maintenance Manual for fuel injection nozzle holder and linesinstallation procedures.3-24. FUEL LINES.Refer to the Operator and Unit Maintenance Manual for fuel lines maintenance instructions.3-25. START AID ASSEMBLY.Refer to the Operator and Unit Maintenance Manual for start aid assembly maintenance instructions.3-67
Page 1:
ARMY *TM 9-6115-464-34AIR FORCETO-3
Page 4 and 5:
ARMY TM 9-6115-464-34AIR FORCE 35C2
Page 7:
ARMY TM 9-6115 464 34AIR FORCE TO 3
Page 11 and 12:
ARMY TM 9-6115-464-34AIR FORCE TO 3
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Table 1-1. FITS AND TOLERANCES (CON
Page 33:
Table 1-1. FITS AND TOLERANCES (CON
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71: ARMY TM 9-6115-464-34AIR FORCE TO 3
Page 166 and 167: ARMY TM 9-6115-464-34AIR FORCE 35C2
Page 168 and 169: ARMY TM 9-6115-464-34AIR FORCE 35C2
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
Page 260 and 261:
Page 262 and 263:
Page 264 and 265:
Page 266 and 267:
Page 268 and 269:
ARMY TM 9-6115-464—34AIR FORCE 35
Page 270 and 271:
Page 272 and 273:
Page 274 and 275:
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283:
Page 284 and 285:
Page 286 and 287:
Page 288 and 289:
Page 290 and 291:
Page 292 and 293:
Page 294 and 295:
Page 296 and 297:
Page 298 and 299:
Page 300 and 301:
Page 302 and 303:
Page 304 and 305:
Page 306 and 307:
Page 308 and 309:
Page 310 and 311:
Page 312 and 313:
Page 314 and 315:
Page 316 and 317:
Page 318 and 319:
Page 320 and 321:
Page 322 and 323:
Page 324 and 325:
Page 326 and 327:
Page 328 and 329:
Page 330 and 331:
Page 332 and 333:
Page 334 and 335:
Page 336 and 337:
Page 338 and 339:
Page 340 and 341:
Page 342 and 343:
Page 344 and 345:
Page 346 and 347:
Page 348 and 349:
Page 350 and 351:
Page 352 and 353:
Page 354 and 355:
Page 356 and 357:
Page 358 and 359:
Page 360 and 361:
ARMY TM 9-6115-464—34AIR FORCE 35
Page 362 and 363:
Page 364 and 365:
(c)(d)(e)Pull all slack from the le
Page 366 and 367:
Page 368 and 369:
Page 370 and 371:
Page 372 and 373:
Page 374 and 375:
Page 376:
Page 379 and 380:
Page 381 and 382:
Page 383 and 384:
Page 385 and 386:
Page 387 and 388:
Page 389 and 390:
Page 391 and 392:
Page 393 and 394:
Page 395 and 396:
Page 397 and 398:
Page 399 and 400:
Page 401 and 402:
Page 404 and 405:
REPAIR INSTRUCTIONSARMY TM 9-6115-4
Page 406 and 407:
Page 408 and 409:
Page 410 and 411:
Page 412 and 413:
Page 414 and 415:
Page 416 and 417:
Page 418 and 419:
Page 420 and 421:
Page 422 and 423:
Page 424 and 425:
Page 426 and 427:
Page 428 and 429:
Page 430 and 431:
Page 432 and 433:
Page 434 and 435:
Page 436 and 437:
Page 438 and 439:
Page 440 and 441:
Page 442 and 443:
Page 444 and 445:
Page 446 and 447:
Page 448 and 449:
Page 450 and 451:
Page 452 and 453:
Page 454 and 455:
Page 456 and 457:
Page 458 and 459:
Page 460 and 461:
Page 462 and 463:
Page 464 and 465:
Page 466 and 467:
Page 468 and 469:
Page 470 and 471:
Page 472 and 473:
Page 474 and 475:
Page 476 and 477:
Page 478 and 479:
Page 480 and 481:
Page 482 and 483:
ARMY TM 9-6115 464 34AIR FORCE TO 3
Page 484 and 485:
Page 487 and 488:
Page 489 and 490:
Page 491:
ARMY TM 9-6115-464-34AIR FORCE TO-3
show all

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

Create successful ePaper yourself

Delete template?

Save as template?