10.07.2015 Views

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

<strong>ARMY</strong> TM 9-<strong>6115</strong>-<strong>464</strong>-<strong>34</strong><strong>AIR</strong> <strong>FORCE</strong> <strong>35C2</strong>-3-445-2NAVY NAVFAC P-8-624-<strong>34</strong>Figure 3-78. Electro-Hydraulic Governor Control Unit Frequency Sensing Test Circuit(3)(4)(5)Place the container in a temperature controlled oven. Set the oven temperature at +180 to + 185°F(+82.2°C to +85°C) and allow the container to soak 11 to 12 hours or until potting compound iscompletely melted.Prior to installing the printed circuit board, remove the container from the oven and make sure thatinsulation paper is positioned next to the container shell.Using heavy gloves and safety glasses, slowly lower the printed circuit board into the pottingcompound.(6)(7)i. InstallationWARNINGUse care not to splash hot potting compound on operating personnel. It can causesevere injury. Failure to observe this warning could result in servere personal injury ordeath.Position the printed circuit board and allow compound to cool.When compound has cooled and is substantially solid, install top cover and hardware.(1) Refer to figure 3-81 for approximate position of controls when connecting linkage. Use figure 3-82for generators with serial No RZ0001.3-178

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!