ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

More documents

Recommendations

Info

ARMY TM 9-6115-464-34AIR FORCE 35C2-3-445-2NAVY NAVFAC P-8-624-34(1)(2)(3)(4)(5)(6)c. Removal.If the FL-NL or NL - FL transient exceeds 1-1/2 percent of rated speed and/or does notreestablish stable engine operating conditions within one second, realign the control unit inaccordance with paragraph 3-64j. Also follow this procedure if the engine speed hunts. If the setcannot be stabilized, check sockets A and B of plug P-21 (figure 3-97) for 24 Vdc (A is positive).If the engine speed increases to above nominal operating speed, check sockets A and B of P-17(figure 3–97) for 120 Vac. If it is missing, troubleshoot the generator set wiring. Refer to schematicand troubleshooting diagram plates located on inside of left and right engine compartment doors(figure 3-97). If it is present, check the resistance of the frequency adjusting circuit consisting of R4(250 ohms) rheostat R1 frequency adjust (500 ohms) and R6 (250 ohms) fixed resistor. Measure thetotal circuit resistance across N and T of harness plug PI 7 (figure 3-97). The circuit resistanceshould be 1000 ohms (5 percent tolerance). After testing for correct total resistance, test theoperation of the frequency adjust rheostat by connecting an ohmmeter across pins M and T andrevolving the frequency adjust rheostat through its entire travel. The resistance should vary from 750ohms to 250 ohms. Repeat this procedure using the ohmmeter across pins M and N of the harnessplug. If the problem persists, check sockets A and B of plug P-21 (figure 3-97) for 24 Vdc (A ispositive).If the engine speed remains below the nominal operating speed, adjust RI. If there is noimprovement, check the resistance of the frequency adjust circuit. Disconnect P–17 and check theresistance of the frequency adjust circuit consisting of R4 (250 ohms) fixed resistor, RI frequencyadjust rheostat (500 ohms) and R5 (250 ohms, 5 percent) fixed resistor. Measure the total circuitresistance across N and T of harness plug P-17. The circuit resistance should be 1000 ohms (5percent tolerance). After testing for correct total resistance, test the operation of the frequency adjustpotentiometer by connecting an ohmmeter across pins M and T and revolving the travel. Theresistance should vary from 750 ohms to 250 ohms. Repeat this procedure using the ohmmeteracross pins M and N of the harness plug. Disconnect actuator electrical connector before making thismeasurement. Push actuator piston all the way down and adjust engine speed with manual throttle.If this value resistance is measured, check sockets A and Bat plug P–21 for 24 Vdc (A is positive).If the set is operating at a constant load and voltage and during an eight–hour period the change inambient temperature does not exceed 60°F, the set frequency should not drift beyond 1/2 of onepercent of rated frequency. The above requirement assumes that the set temperatures werestabilized at the initial and final ambient temperatures.NOTEIf the drift in paragraph (4) is excessive, realign the control unit following the procedureoutlined in paragraph 3-64j.At constant ambient temperature, constant load, constant voltage and constant barometric pressure,the set frequency should remain within a bandwidth of 1 percent of rated frequency for a period of 4hours. If this bandwidth has been exceeded, realign the control unit in accordance with paragraph3-64j.If the preceding solutions to the specific problem do not resolve the problems, replace and repair thecontrol unit, actuator (paragraph 3-43) or load measuring unit (paragraph 3–63) as required.(1) Tag and disconnect electrical connectors to governor control unit.(2) Remove nuts (1, figure 3-68), Iockwashers (2), nuts (3), Iockwashers (4) and bracket (5), threadedrod (6) and lift governor control unit from mounting bracket.3-158
ARMY TM 9-6115-464-34AIR FORCE TO 35C2-3-445-2NAVY NAVFAC P-8-624-34LEGEND:G1 POWER SOURCE, 208 VAC, 3 PHASE, 47-430 HZM1 VOLTMETER, 0-250 VACM2 VOLTMETER, 0-10 VDCM3 VOLTMETER, 0-10 VACR1 LOAD BANKR2 LOAD RESISTOR, 7.5 OHM, 10 WATTR3 LOAD RESISTOR, 7.5 OHM, 10 WATTR4 LOAD RESISTOR, 7.5 OHM, 10 WATTT1 TRANSFORMERT2 TRANSFORMERT3 TRANSFORMERFigure 3-67. Load Measuring Unit Test Circuit and Test Data Relationship3-159
Page 1:
ARMY *TM 9-6115-464-34AIR FORCETO-3
Page 4 and 5:
ARMY TM 9-6115-464-34AIR FORCE 35C2
Page 7:
ARMY TM 9-6115 464 34AIR FORCE TO 3
Page 11 and 12:
ARMY TM 9-6115-464-34AIR FORCE TO 3
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Table 1-1. FITS AND TOLERANCES (CON
Page 33:
Table 1-1. FITS AND TOLERANCES (CON
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163: ARMY TM 9-6115-464-34AIR FORCE TO 3
Page 164 and 165: ARMY TM 9-6115-464-34AIR FORCE TO 3
Page 166 and 167: ARMY TM 9-6115-464-34AIR FORCE 35C2
Page 262 and 263:
Page 264 and 265:
Page 266 and 267:
Page 268 and 269:
ARMY TM 9-6115-464—34AIR FORCE 35
Page 270 and 271:
Page 272 and 273:
Page 274 and 275:
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283:
Page 284 and 285:
Page 286 and 287:
Page 288 and 289:
Page 290 and 291:
Page 292 and 293:
Page 294 and 295:
Page 296 and 297:
Page 298 and 299:
Page 300 and 301:
Page 302 and 303:
Page 304 and 305:
Page 306 and 307:
Page 308 and 309:
Page 310 and 311:
Page 312 and 313:
Page 314 and 315:
Page 316 and 317:
Page 318 and 319:
Page 320 and 321:
Page 322 and 323:
Page 324 and 325:
Page 326 and 327:
Page 328 and 329:
Page 330 and 331:
Page 332 and 333:
Page 334 and 335:
Page 336 and 337:
Page 338 and 339:
Page 340 and 341:
Page 342 and 343:
Page 344 and 345:
Page 346 and 347:
Page 348 and 349:
Page 350 and 351:
Page 352 and 353:
Page 354 and 355:
Page 356 and 357:
Page 358 and 359:
Page 360 and 361:
ARMY TM 9-6115-464—34AIR FORCE 35
Page 362 and 363:
Page 364 and 365:
(c)(d)(e)Pull all slack from the le
Page 366 and 367:
Page 368 and 369:
Page 370 and 371:
Page 372 and 373:
Page 374 and 375:
Page 376:
Page 379 and 380:
Page 381 and 382:
Page 383 and 384:
Page 385 and 386:
Page 387 and 388:
Page 389 and 390:
Page 391 and 392:
Page 393 and 394:
Page 395 and 396:
Page 397 and 398:
Page 399 and 400:
Page 401 and 402:
Page 404 and 405:
REPAIR INSTRUCTIONSARMY TM 9-6115-4
Page 406 and 407:
Page 408 and 409:
Page 410 and 411:
Page 412 and 413:
Page 414 and 415:
Page 416 and 417:
Page 418 and 419:
Page 420 and 421:
Page 422 and 423:
Page 424 and 425:
Page 426 and 427:
Page 428 and 429:
Page 430 and 431:
Page 432 and 433:
Page 434 and 435:
Page 436 and 437:
Page 438 and 439:
Page 440 and 441:
Page 442 and 443:
Page 444 and 445:
Page 446 and 447:
Page 448 and 449:
Page 450 and 451:
Page 452 and 453:
Page 454 and 455:
Page 456 and 457:
Page 458 and 459:
Page 460 and 461:
Page 462 and 463:
Page 464 and 465:
Page 466 and 467:
Page 468 and 469:
Page 470 and 471:
Page 472 and 473:
Page 474 and 475:
Page 476 and 477:
Page 478 and 479:
Page 480 and 481:
Page 482 and 483:
ARMY TM 9-6115 464 34AIR FORCE TO 3
Page 484 and 485:
Page 487 and 488:
Page 489 and 490:
Page 491:
ARMY TM 9-6115-464-34AIR FORCE TO-3
show all

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?