10.07.2015 Views

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>ARMY</strong> TM 9-<strong>6115</strong>-<strong>464</strong>-<strong>34</strong><strong>AIR</strong> <strong>FORCE</strong> <strong>35C2</strong>-3-445-2NAVY NAVFAC P-8-824-<strong>34</strong>(7) Install flatwasher (10), Iockwasher (9), and screw (8).(8) Install terminal block (7), screw (6) and screw (5).(9) Install nut (4), clamp (3), Iockwasher (2) and screw (1).3-100. GENERALSection XVI. MAINTENANCE OF LIFTING FRAMEThe lifting frame is securely attached to the skid base. It is equipped with lifting clevises at the top of eachside for lifting equipment attachment. In addition, the lifting frame provides support for the center of the housingassembly and serves as a mounting point for the hydraulic sump and the day tank assembly. During generatorassembly removal, the lifting frame provides support for the rear of the engine assembly.3-101. LIFTING FRAME MAINTENANCE.a. Removal.(1) Remove housing assembly doors and panels as required for lifting frame removal (paragraph 3-99).(2) Remove hydraulic sump (paragraph 3-41).(3) Remove fuel lines and fittings (paragraph 3-24) and day tank assembly (paragraph 3-20).(4) Remove main fuel tank filler neck (paragraph 3-16).(5) Remove nut (1, figure 3-151), Iockwasher (2), screw (3), and flat washer (4).(6) Remove nut (5), Iockwasher (6), spacer (7), screw (8) and flatwasher (9).(7) Remove nut (10), Iockwasher (11), screw (12), flatwasher (13), top support (15) and right support(16).(8) Remove nut (17), Iockwasher (18), screw (19), flat washer (20) and bracket (21).(9) Remove clevis assembly (22).(10) Remove nut (28), lockwasher (29), hex nut (30), screw (31) and flat washer (32).NOTEIt is not necessary to completely disassemble the lifting frame to replace a single partOnly those parts requiring repair or replacement need be removed.b. Cleaning, Inspection, and Repair.WARNINGSolvent, Dry Cleaning P-D-680, Type II is flammable and moderately toxic to skin,eyes and respiratory tract. Eye and skin protection required. Good general ventilationis normally adequate. Failure to observe this warning could result in servere personalinjury or death.(1) Clean all parts in dry cleaning solvent (Federal Specification P-D-680) and dry thoroughly.(2) Inspect supports, lifting clevises and brackets for cracks, corrosion, breaks, defective paint, andother damage.(3) Inspect lifting clevises, brackets, and pins for excessive wear.3-314

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!