10.07.2015 Views

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>ARMY</strong> TM 9-<strong>6115</strong>-<strong>464</strong>-<strong>34</strong><strong>AIR</strong> <strong>FORCE</strong> <strong>TO</strong> <strong>35C2</strong>-3-445-2NAVY NAVFAC P-8-624-<strong>34</strong>Figure 3-51 .Dimensional Inspection of Camshaft(11) If dimension obtained in step (8) indicates excessive wear, replace camshaft bearings as follows:(a) Using a suitable press, remove camshaft bearings from cylinder block.CAUTIONMake sure that the replacement bearings are installed so that oil holes match with oilports in cylinder block. Failure to observe this caution could result in equipmentdamage.(b) Press replacement bearings into cylinder block.d. Assembly.(1) Install thrust plate (7, figure 3–50), key (6) and press shaft (5) into gear.(2) Install support drive gear (4) onto arbor press with nut (3).(3) Torque nut (3) to 130 ft-lbs.e. Installation.CAUTIONMake sure that timing mark on camshaft drive gear mates with timing mark oncrankshaft gear. Failure to observe this caution could result in equipment damage.NOTEValve tappets must be in the UP position to install camshaft.(1) Refer to figure 3-45 to insure proper timing of camshaft gear to crankshaft gear is obtained.(2) Install valve tappets (35, figure 3-46).3-119

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!