10.07.2015 Views

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>ARMY</strong> TM 9-<strong>6115</strong>-<strong>464</strong>-<strong>34</strong><strong>AIR</strong> <strong>FORCE</strong> <strong>TO</strong> <strong>35C2</strong>-3-445-2NAVY NAVFAC P-8-624-<strong>34</strong>Section IV. LOAD BANK5-19. GENERAL.The load bank is used to apply up to 50 percent of the generator rated load to prevent carbon buildup in theengine due to light loads. It is a balanced three phase, air cooled, resistive load which maybe operated ateither 120/208 or 240/416 volts. Generator load is selected through the load selector switch in increments of12.5 percent rated generator load.5-20. CONTROL BOX ASSEMBLY.a. Removal. Refer to the Operator and Unit Maintenance Manual for control box assembly removalprocedures.b. Disassembly.(1) Remove load selector switch, circuit breaker, and indicator light as instructed in the Operator andUnit Maintenance Manual.(2) Remove screw and captive washer assemlby (1, figure 5-14), and backup plate (2).(3) Remove nut (3), screw & captive washer assembly (4), and branched wiring harness (5).(4) Remove nut (6), screw & captive washer assembly (7), and branched wiring harness (12).(5) Remove protective cap (8).(6) Remove nut (9), and screw & captive washer assembly (10).(7) Remove protective cap (11).(8) Remove screw & captive washer (13), and load sensing module (14).(9) Remove nut (15), tooth Iockwasher (16), mode selector switch (17), and nut (18).(10) Remove nut (19), screw & captive washer (20), transformer (21), and chassis (22).c. Cleaning, Inspection. and Repair.WARNINGCompressed air used for cleaning and drying purposes can create airborne particlesthat may enter the eyes. Pressure shall not exceed 30 psig and use only with adequatechip guards and chipping goggles. Failure to observe this warning could result inservere personal injury or death.WARNINGSolvent, Dry Cleaning P–D-680, Type II is flammable and moderately toxic to skin,eyes and respiratory tract. Eyes and skin protection required. Good general ventilationis normally adequate. Failure to observe this warning could result in servere personalinjury or death.(1) Clean all electrical parts with filtered compressed air and a soft bristle brush. If necessary, removecaked deposits with a clean, lint-free cloth moistened with solvent P-D-680 Type Il.(2) Clean chassis and back plate with dry cleaning solvent (Federal Specification P-D-680) and drythoroughly.(3) Inspect load sensing module for cracks, corroded terminals, and burns or other evidence of shorting.5-36

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!