ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

ARMY TM 9-6115-464-34AIR FORCE 35C2-3-445-2NAVY NAVFAC P-8-624-34(13) Install screw & captive washer assembly (10), and nut (9).(14) Install potentiometer (8), tooth Iockwasher (7), nut (6) and locking nut (5).(15) Position chassis (46) to install cover (4), and screw & captive washer assembly (3)e. Installation.(1) Position special relay assembly to install Iockwashers (2, figure 3-119) and screws (l).(2) Connect electrical connectors to special relay assembly.3-91. PRECISE RELAY ASSEMBLY.a. Removal.WARNINGDo not attempt to perform maintenance on the precise relay assembly while thegenerator is operating. Severe electrical shock may result from failure to observe thiswarning.(1) Disconnect electrical connectors to precise relay assembly.(2) Remove screws (1, figure 3-123) and Iockwashers (2) to remove precise relay assembly fromgenerator set.b. Disassembly.(1)(2)(3)(4)NOTEDisassemble only as required to clean, inspect, test, or replace parts.Remove screw & captive washer assembly (3, figure 3–1 23) and cover (4).Remove locknuts (5), nut (6), tooth lockwasher (7) and rheostat (8).Remove nut (9), tooth Iockwasher (10), positioning washer (11), and switch (12).Remove nut & captive washer assembly (13), flat washer (14), nut & captive washer assembly (15),and screw (16).(5)(6)(7)(8)(9)(10)Remove nut (17), screw & captive washer assembly (18) and wiring harness (19).Remove screw and captive washer assembly (20) and under voltage relay (21).Remove nut (22), screw & captive washer assembly (23) and electronic components assembly (24).Remove nut & captive washer assembly (25), screw (26), terminal board assembly (27) and terminaljumper (28).Remove screw & captive washer assembly (29) and under frequency relay (30).Remove screw & captive washer assembly (31), permissive paralleling relay (32) and chassis (33).NOTESwitch and attaching hardware (items 21 through 24) are found only on the 50/60 Hzprecise relay assembly.3-252