ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

More documents

Recommendations

Info

ARMY TM 9-6115-464-34AIR FORCE TO 35C2-445-2NAVY NAVFAC P-8-624-34CHAPTER 4GENERATOR SET TESTS AFTER OVERHAUL REPAIR INSTRUCTIONSSection I. INSPECTION4-1. GENERAL.a. The activity performing the repair or overhaul is responsible for the performance of all applicable tests andinspections specified herein. Activities performing maintenance on any portion of the generator set mustperform those tests and inspections required by the applicable component or system repair instruction.b. A thorough inspection of the generator set shall be conducted to insure that workmanship and materialsare satisfactory.c. The inspection shall be conducted each time the generator set is overhauled or rebuilt.4-2. HOUSING AND FRAME INSPECTION.a. Check that lifting eyes are installed and firmly secured.b. Check that drain holes are open to prevent moisture accumulation.c. Insure that exposed parts are properly treated to resist corrosion.d. Open and close panel doors, engine area doors, and generator area doors to insure proper installationand freedom of motion.e. Inspect movable door gasketing to insure that it is weatherproof.f. Check that all caps and covers are equipped with ties, chains, or other ties to prevent loss.4-3. ENGINE INSPECTION.a. Check mounting bolts of all components and accessories to insure that they are firmly secured.b. Check designation and data plates for legibility.c. Insure that fuel and hydraulic oil lines are protected from damage due to vibration.4-4. GENERATOR INSPECTION.a. Insure that generator leads are properly identified and protected from damage due to vibration.b. Insure that inspection openings are protected by screening or protective plates.c. Check that the engine generator screws are firmly secured. See paragraph 1-10v, for proper torquevalues.4-5. ELECTRICAL ACCESSORIES INSPECTION.a. Check all cable and harness assemblies for secure fastenings and protection against chafing andvibration.b. Insure that all cable and harness connectors are firmly secured in their proper place.4-1
ARMY TM 9-6115-464-34AIR FORCE TO 35C2-3-445-2NAVY NAVFAC P-8-624-34Section Il. OPERATING TESTS4-6. GENERAL.a. The tests described in this section require generator set operation and provide verification of generatorset performance characteristics.NOTEAll tests shall be conducted with the 240/416 volt connections, unless otherwisespecified. All tests that are applicable, will be conducted on both Mode I and Mode IIgenerator sets. Mode I tests shall be conducted at 60 Hz only unless otherwisespecified.b. Unless otherwise specified, all test instrumentation will be in accordance with Military StandardizationHandbook MIL-HDBK-705 and Military Standard MIL-STD-705.c. Temperatures will be measured by means of appropriately located thermocouples and properly calibratedread out devices. Thermocouples will be insulated from contact with other metals, as practical. Temperatureswill be recorded in degrees Fahrenheit or Centigrade, depending on the instrument scale, but will be convertedto degrees Fahrenheit in all cases. Barometric pressures will be measured by a mercurial barometer which willbe corrected for the temperature of the scale, the mercury, for vapor pressure and for the location of thebarometer with regard to altitude and latitude. Aneroid barometers will not be used.d. Operation procedures required in support of the individual tests specified herein shall be performed as inthe Operator and Unit Maintenance Manual.e. All test results for generator set overhaul, shall be logged on the appropriate forms as required.f. Perform the operating tests as indicated in table 4-1.4-7. DIRECTION OF ROTATION CONTROLS.With the generator set running at a rated load, rotate the following controls and verify their proper operation.a. Frequency Adjust Control. On Class 1 sets clockwise rotation of the frequency adjust control rheostatmust cause set frequency to increase as indicated on the frequency meter. On Class 2 sets counterclockwiserotation of manual speed control must increase frequency.b. Voltage Adjust Control. Clockwise rotation of the voltage adjust control must cause set voltage to increaseas indicated on the voltmeter.c. Governor Paralleling Control (Class 1 Sets Only). Counterclockwise rotation of the governor parallelingcontrol must cause an increase in the signal appearing at the paralleling receptacles.d. Voltage Regulator Paralleling Control. Clockwise rotation of the voltage regulator paralleling control mustcause that set to increase its share of the total reactive Kva.4-8. REVERSE POWER PROTECTIVE DEVICE TESTa. Operate two generator sets in parallel at no load, with contractors closed.b. Lower speed of set being tested until the main contactor opens.c. Record the value on the kilowatt meter of the other set at the moment the contactor opens. The loadcontactor of the set under test must open when power flow into the generator exceeds 20 percent of the ratedvalue.4-2
Page 1:
ARMY *TM 9-6115-464-34AIR FORCETO-3
Page 4 and 5:
ARMY TM 9-6115-464-34AIR FORCE 35C2
Page 7:
ARMY TM 9-6115 464 34AIR FORCE TO 3
Page 11 and 12:
ARMY TM 9-6115-464-34AIR FORCE TO 3
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Table 1-1. FITS AND TOLERANCES (CON
Page 33:
Table 1-1. FITS AND TOLERANCES (CON
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
Page 260 and 261:
Page 262 and 263:
Page 264 and 265:
Page 266 and 267:
Page 268 and 269:
ARMY TM 9-6115-464—34AIR FORCE 35
Page 270 and 271:
Page 272 and 273:
Page 274 and 275:
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283:
Page 284 and 285:
Page 286 and 287:
Page 288 and 289:
Page 290 and 291:
Page 292 and 293:
Page 294 and 295:
Page 296 and 297:
Page 298 and 299:
Page 300 and 301:
Page 302 and 303:
Page 304 and 305:
Page 306 and 307:
Page 308 and 309:
Page 310 and 311:
Page 312 and 313:
Page 314 and 315:
Page 316 and 317:
Page 318 and 319:
Page 320 and 321:
Page 322 and 323:
Page 324 and 325:
Page 326 and 327: ARMY TM 9-6115-464-34AIR FORCE 35C2
Page 360 and 361: ARMY TM 9-6115-464—34AIR FORCE 35
Page 364 and 365: (c)(d)(e)Pull all slack from the le
Page 366 and 367: ARMY TM 9-6115-464-34AIR FORCE TO 3
Page 376: ARMY TM 9-6115-464-34AIR FORCE TO 3
Page 404 and 405: REPAIR INSTRUCTIONSARMY TM 9-6115-4
Page 428 and 429:
Page 430 and 431:
Page 432 and 433:
Page 434 and 435:
Page 436 and 437:
Page 438 and 439:
Page 440 and 441:
Page 442 and 443:
Page 444 and 445:
Page 446 and 447:
Page 448 and 449:
Page 450 and 451:
Page 452 and 453:
Page 454 and 455:
Page 456 and 457:
Page 458 and 459:
Page 460 and 461:
Page 462 and 463:
Page 464 and 465:
Page 466 and 467:
Page 468 and 469:
Page 470 and 471:
Page 472 and 473:
Page 474 and 475:
Page 476 and 477:
Page 478 and 479:
Page 480 and 481:
Page 482 and 483:
ARMY TM 9-6115 464 34AIR FORCE TO 3
Page 484 and 485:
Page 487 and 488:
Page 489 and 490:
Page 491:
ARMY TM 9-6115-464-34AIR FORCE TO-3
show all

ARMY *TM 9-6115-464-34 AIR FORCE TO-35C2-3 ... - Igor Chudov

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?